Electronics Forum | Mon May 09 19:27:19 EDT 2022 | mikevb
Thanks for the response. Yes, the z motor initializes in the service program just fine. It moves and reads a position. Also in the service program, I try to test the z force sensor and it gives me the same error - no z indicator at all. All cables ar
Electronics Forum | Wed May 11 17:25:22 EDT 2022 | SMTA-64387687
You've replaced the sensors and cleaned any grease residue inside the Midas head, and you're still getting this error. You can check the connector on the little board, on top of the Midas, where the flex cable plugs in. I don't remember, off the t
Electronics Forum | Mon May 09 19:00:47 EDT 2022 | SMTA-64387687
Z-force sensor is a tool travel indicator. It has nothing to do with Z travel. Does the Midas head move at all, during initiation? It sounds to me like a Z motor/encoder problem. Is the Midas head ribbon cable plugged in?
Electronics Forum | Wed May 04 19:38:57 EDT 2022 | mikevb
I have a used MyData My9 machine that I've picked up recently and it has a problem with initializing that I can't figure out. It just gives an error stating "no z indicator value at all". I've replaced the flex board with the force sensors but that d
Electronics Forum | Wed May 11 20:25:38 EDT 2022 | mikevb
Thanks. Yes, I replaced the ffx board with a new one and made sure everything is cleaned. I did check the flex cable connect as I removed all of that to test continuity between everything. It all checked out continuity wise. I also tried to disable t
Electronics Forum | Thu Dec 21 17:04:28 EST 2023 | cyber_wolf
Disable the hydra head.
Electronics Forum | Sun Dec 17 13:52:59 EST 2023 | tomdegas
How can I bypass the " Hydra force sensor can't calibrate" during the "Hardware Initialization" test. This is stopping me from starting the machine.
Electronics Forum | Thu Dec 28 20:46:49 EST 2023 | padawanlinuxero
I was use to work with the machine but it has being several years since I had one in my hands, but i got the same error message, I kinda remember there are some sensors in the top part of the hydra try to see if theres dirt or something not letting t
Electronics Forum | Tue Jul 05 22:10:42 EDT 2022 | nellegaard
I am currently trying to setup a used MyData My19 machine and am currently having issues installing tools getting errors such as failed to pick up tool and Z force sensor failed. I have tried to clean the tool pickup area as well as clean and lubrica
Electronics Forum | Wed Jan 05 11:26:15 EST 2005 | cyber_wolf
Then Z MOTOR > Then select>CALIBRATE FORCE SENSOR NOTE: you must have a tool in the head when you do this.(Without the tip/spring pushed in) After this calibration the force should drop to 0 when you push in on the spring loaded tip. 2.) Replace th
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
winsouce.jpg)