Electronics Forum | Fri Apr 26 16:26:55 EDT 2013 | emeto
Hi, thanks for your answer. I was thinking to go even deeper by counting the hours the paste was exposed, but it probably doesn't make a lot of sense, especially considering the fact that my operators will add paste when the level goes too low. I wi
Electronics Forum | Fri Apr 26 15:01:09 EDT 2013 | jorge_quijano
Hola Evtimov, I do the same with my Solder Paste Jars, there is a label that is filled by the warehouse guy & by the line operator; time & date the jar arrived to plant, time & date the jar was taken to production line (out of the refrigerator) and t
Electronics Forum | Wed Apr 07 13:15:26 EDT 1999 | Chrys Shea
| | Dear Sirs | | We are about to start up a new facility for computer prepherals assembly in Egypt hence we need some advice would you please help ? | | 1- What is the most suitable material for floor considering Anti static precautions. | | I have
Electronics Forum | Tue Oct 26 15:44:35 EDT 2004 | Paul_pmd
Hi Mike, Surface mount components arn't difficult to work with at all. They have pretty much the same tolorance to heat degridation as Dip packages. I suggest two Irons when working with two pole resistors and caps. Heating only one end at a time wil
Electronics Forum | Wed Jan 20 18:57:06 EST 2021 | echanelo
Hello, I'm in desperate need of a boot up disk for my Electrovert Omniflo 5 oven. Type: OMNI 5SE Date: 5/98 I would like to purchase or borrow. Or maybe someone can point me the right direction it would be greatly appreciated. Thanks
Electronics Forum | Thu Mar 23 23:21:10 EST 2006 | AR
100 cm/min) the motor runs without complaint. Too bad we run the conveyor as slowly as 10 cm/min... I'll try replacing the control board next when I get my hands on one.
Electronics Forum | Tue Apr 05 03:16:45 EDT 2011 | grahamcooper22
one of my customers with a BTU VIP 70 has the following settings, 100 / 175 / 210 / 250 / 265 with conveyor speed of 18 ins per minute. They get a peak temp of 240~245C and time above liquidus of 220 C is @ 55 secs. Built in thermocouples should give
Electronics Forum | Wed Sep 25 11:12:48 EDT 2013 | derekj
Hello all. Running a new to us Omniflo 5 and realized that there is no ports for thermocouplers or wires to do any profiling. There is a space on a front panel for thermal profiling inputs, so I am assuming it was optional, just not spec'ed on this m
Electronics Forum | Mon Oct 26 12:56:23 EDT 2009 | rgduval
Eric, Protective sleeve? The sleeving protecting the wires of the thermocouples? I bought mine direct from Heller. I think it was $90 for a set of 3 (my oven uses 3 thermocouples). They are close to thirty feet long (I'm guessing...they're much
Electronics Forum | Fri Mar 26 21:36:03 EDT 2010 | cusackmusic
I posted this once, but it disappeared. Anyway, we have an Ersa Hotflow 5 that is our backup, but I doesn't power up anymore. I've called Ersa several times, and they don't return my calls. It powers up, and communicates with the PC, but the scree
