Electronics Forum | Thu Aug 13 14:43:23 EDT 2015 | alphatronique
HI i try to figure how the "Manual load adapter" work on a T3 Table machine ? seem that the table always try to move the board to the the left sensor location ,but if i use the magnet manual table it will never find the board on the table convey
Electronics Forum | Mon Aug 06 14:08:56 EDT 2012 | dyoungquist
We run a MY12 and our largest layout has 9700 components of which about 8500 (88%) are placed by the Hydra head. Average run time for our layout is 75 minutes. Based on that and depending on what percentage of your components are Hydra mountable, y
Electronics Forum | Fri Feb 03 12:25:34 EST 2012 | cyber_wolf
The camera is probably clipping the top of your board when it is reading fids. This causes the motor to lose steps. Manually load a board to vision height and drive the camera over the board to check for clearance issues.
Electronics Forum | Mon Apr 26 18:45:32 EDT 2021 | rgduval
I've had the most success in a check/double-check set up. Most people will tell you that it's labor intensive, and they're not wrong. However, I suspect that those people have never had to manually change two components on a thousand boards at a sh
Electronics Forum | Fri May 09 00:18:42 EDT 2014 | tuanly
To all experts in house, If by chance any one can tell me where to buy or down load the Owner Manual /User guide book for Quad -QSP-II SMT machine. Or step by step instruction how to teaching board Fiducial on this Quad QSP-II. Thank you all in adva
Electronics Forum | Tue Sep 01 12:20:47 EDT 2009 | fujiphil
Manually load the board and activate the solenoid for table up/down. Goto I/O then check the status of the sensor. if the sensor was tripped when table is down, removed the pin and check for foreign objects. Or check the hole of the pcb, maybe the si
Electronics Forum | Sat Sep 28 15:58:38 EDT 2013 | sonavc
Hi. 'm new to this Fuji CP3, I bought this machine in working condition ( I saw it ran, but I forgot to check the board in and out ).... Moved to my location, Problem: When the board is trying to load to the X-Y table, it passed the conveyor B but
Electronics Forum | Thu Oct 06 00:41:56 EDT 2005 | vinitverma
Hi, If you're thinking of a new machine and the volumes are not very high, I think Assembleon's OPAL XII should be the best fit. It can handle VERY LARGE boards upto 25.5" x 17" (with single pass) and 25.5" x 33.5" (with double pass). However for th
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Fri Nov 20 00:14:23 EST 2015 | ttheis
To clarify- what I have is: 1. Manual stencil print process 2. Dynapace conveyor into GSM 3. Dynapace conveyor out of GSM into oven So what I need is a way to tell the conveyor into the placement machine to "go" when a board is loaded onto it after
