Electronics Forum | Wed Jun 27 14:36:22 EDT 2012 | cyber_wolf
If the X axis is moving then maybe your Elmo is not adjusted correctly. There is a procedure to adjust it in the manual(assuming you have the original manual). The correct location is XGTS which is a white connector on the booster. The fans are 24V
Electronics Forum | Fri Jul 10 18:47:27 EDT 2015 | alphatronique
make sure noting stock in the X ,and motor brake work usually machine supply 24V to motor brake wire for release brake then move until hit the end stopper for init motor if brake keep on that will the error message i got it often on the Z cause
Electronics Forum | Fri Jul 10 19:53:31 EDT 2015 | tamazula
make sure noting stock in the X ,and motor brake > work usually machine supply 24V to motor brake > wire for release brake then move until hit the > end stopper for init motor if brake keep on > that will the error message > > i got it ofte
Electronics Forum | Wed Oct 23 02:45:17 EDT 2019 | maxwilko
Hello there, My 'MyChronic MyData My500 Solder Jet printer' keeps having the same issue and I am unable to solve the issue. Suction flow too low: Check filter box and suction holes are clear. This problem would usually be solved by a new filter bo
| 1 |
