Electronics Forum | Tue Feb 11 00:21:54 EST 2014 | bren
I suddenly encountered this error F-AXIS-C/9 Error says Axis has unstable zero point. Any advise?
Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Thu Feb 20 13:16:15 EST 2014 | rgduval
Hi, Brendan, It sure sounds like it to me. But, with the Z axis, there could be one other thing to check. On my old TP, there were z-locks...two pistons that pointed sideways around the head travel. Initializing the z-motors did not move the z-
Electronics Forum | Fri Nov 02 22:30:04 EDT 2018 | ecdave
Hello. Hoping to find help troubleshooting z axis issue. Initializes OK, and runs a bit sometimes not going all the way down to reach feeder, misses part and tries again, usually successfully, before ultimately stopping for "F-MOT-MOVE INDVACWAIT Z/2
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Wed Feb 06 11:24:19 EST 2002 | mrpsilva
Thanks in advance for your help. I am looking for the following board: MYDATA � Elmo EBAF 25/400RHI � controller for X axis If you need pictures, please let me know in order to send you Thanks Marcos
Electronics Forum | Sat Jul 28 09:25:10 EDT 2007 | mleber
We are new users to the Mydata product line. We are getting the following error F-Axis-23: X Transducer CH 1 ptp value too low. Has anyone had this error and lend some assistance? Thanks in advance.
Electronics Forum | Sat Jun 25 01:05:13 EDT 2005 | pci
check the X axis belt , guides and Z axis motor
Electronics Forum | Tue Jun 26 15:05:02 EDT 2012 | upguy
Thanks for responding Fred and Peter. We have had the same damage to the tip occur even though our TP9-UFP sits in an air conditioned room (74 F / 23 C). I spoke with Matt at MyData (who was very helpful). He said that the X-axis bearings, the X-a
Electronics Forum | Tue Jan 15 17:06:04 EST 2002 | pjc
The Mydata machine's Y-axis moving does not affect parts already placed on the board. The machine has very sophisticated acceleration and deceleration to account for this. There are many users of Mydata machines running 0.3mm pitch and large heavy pa
