Electronics Forum | Tue Aug 28 11:03:40 EDT 2012 | mikesewell
The problem is still intermittent. It has a new MIDAS head, installed and calibrated by Mydata, FWIW. Usually we work around it by moving parts upstream (Fuji AIM). I'll post an update when I finally chase the issue down.
Electronics Forum | Fri Oct 17 12:48:59 EDT 2014 | cyber_wolf
The only reason you would need to run this calibration is if the camera was replaced or the centering camera got whacked which is highly unlikely. If your placements are off, put an offset in the parameter file.
Electronics Forum | Tue Mar 15 17:47:24 EDT 2022 | guyt
Hi, Has anyone had a issue with a MyData my12 dual camera system, were the calibration always shifts up after a few hours of use. It's not the mechanical calibration. it is like the machine loses it's software calibration co-ordinates ?? Any ideas
Electronics Forum | Fri Jun 10 09:08:09 EDT 2005 | ??
Sounds to me like someone had some mydata's and didnt know exactly how to calibrate them.....then that somebody purchased some brand new fuji's that were calibrated perfectly (which they should be when brand new) and that would be the difference. I h
Electronics Forum | Fri Oct 17 09:38:07 EDT 2014 | rgduval
Are you able to turn off mechanical centering? Or can you adjust the settings?
Electronics Forum | Thu Oct 16 12:35:03 EDT 2014 | upguy
We have tpsys 1.5.18 on our TP9-UFP. We are attempting to run "Optical Centering Calibration". Following the instructions in the manual, we have centered the cross hairs on the camera frame, loaded a "base" board then the L-19-447 calibration boar
Electronics Forum | Tue Apr 24 02:07:27 EDT 2001 | joe
It's not so much of a change but a new investment. We have Siplace lines now, and very pleased with the performance. The reason for looking at the Mydata is to remove all the small stuff from the faster lines and reduce changeover times. The idea is
Electronics Forum | Mon Apr 29 17:19:34 EDT 2002 | Jimmy
The Agilis feeders perform as advertised after having them in use for several months. They significantly reduce the time it takes to load and unload feeders and don't require maintenance and calibration (unlike traditional feeders and the older Mydat
Electronics Forum | Tue Apr 02 17:56:44 EDT 2024 | mistrthou
You'll need the specific Mydata part. It has some specific dots and square printed on it. It should be in a box with other calibration parts, stuff which we do at least every 6 months. I attached an internet picture of the box that contains the diff
Electronics Forum | Mon Mar 06 11:13:08 EST 2006 | fredericksr
I ran this same process by MyData when I was there for training and I received the message that calibrating the force sensor through the service menu was an invalid technique. Correct me if I am wrong, but every tool should recalibrate itself when i
