Electronics Forum | Sat Nov 08 00:28:25 EST 2014 | padawanlinuxero
Hello We a Mydata and put all kinda of components with the midas unit, but never had problems with ESD, and some of them are very delicate parts, perhaps like our colleague said perhaps you should look at the trays or feeders that you are using, pe
Electronics Forum | Mon Jul 02 09:30:19 EDT 2007 | cyber_wolf
Make sure that your C14 tool is black and that the tip is in good condition. Next, create a vision package for the 0402. I assume that your machine has a line scan camera.(Use it) 0402's do not mechanically center well unless your C14 and centering u
Electronics Forum | Tue Jul 10 16:13:52 EDT 2007 | bk
Hi folks, I've been bouncing off of MyData > technical support for some time on an issue with > a MyData machine. Seems that this My9 likes to > skip an 0402 placement at a rate of ~ > 1000/million. > > Profile: MyData > My9 Mechanical ce
Electronics Forum | Mon May 13 11:05:49 EDT 2013 | shankar2013
I have moved the MOT cards. The messages are still the same. Booster +25V is stable, The BM3 +25V indicator shows no +25V which means any of the feeds down the chain pulled it down. So basically once it is low the relays in the BM3 card will not latc
Electronics Forum | Thu Jul 12 07:52:08 EDT 2007 | cyber_wolf
I agree avalancher. Your description is a valid point. But, I am still under the impression that the vac level is a separate issue. His original problem was 0402's missing off the board ,and weird measurements showing up when parts get rejected. I w
Electronics Forum | Tue May 07 16:19:47 EDT 2013 | dyoungquist
The "25v reads 3V" part of the error message may be your clue. Since the machine runs for a while and then shuts down, something may be failing after it warms up. "F-AXIS-182:C-AXIS NOT properly out when expected" refers to the centering jaws not o
Electronics Forum | Fri Jul 07 13:20:37 EDT 2006 | fredericksr
I've seen the tool head move components if the component list isn't grouped according to size. If you group your taller components higher than the others then they will be placed later. I used to see a lot of shifting with large keyhole vias used
Electronics Forum | Fri Apr 08 16:26:36 EDT 2005 | Grant
Hi, It seems weird that an automated pick and place machine at a board shop would not be up to NASA standards, but placing the components by hand would be. However most SMT will self center a bit, so if your close enough, you should be ok. You rea
| 1 |
