Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Thu Aug 14 12:57:45 EDT 2014 | rgeary
Does anyone know what the following error indicates on a MyData My12 running 2.9.2. "F-MOT-MSETDYN C/156"?
Electronics Forum | Fri May 24 11:34:08 EDT 2019 | jstebbs89
Running a Mydata 15E and in the middle of a board the machine will freeze. Restart the machine and try to initiate the hardware, get an error message of F-MOT-MSETDYN X/163: Illegal value of DSP command arguement I've check all the connections on t
Electronics Forum | Fri May 24 13:04:10 EDT 2019 | tey422
Have you tried to test the X-axis stepping? I am suspecting might have to do with the Encoder with X-Magnetic strip.
Electronics Forum | Tue Nov 13 11:14:15 EST 2012 | jaimebc
For the past few weeks we have experienced an intermitent midas theta error.During normal production the machine times out while just after picking up a component waiting for the theta to center it.Sometimes it fails to leave a tool. Reinitianing the
Electronics Forum | Thu Mar 23 13:36:30 EDT 2023 | tomdegas
Running a Mydata MY 9 and trying to Restart the machine and try to initiate the hardware, get an error message of F-MOT-MSETDYN X/163: Illegal value of DSP command argument. It seems to be related to the x drive. I've check all the connections on
Electronics Forum | Tue Apr 02 15:03:45 EDT 2024 | tey422
I believe you need one of this https://www.pfipartsus.com/products/mydata-l-019-0633-1
Electronics Forum | Thu Mar 28 16:11:12 EDT 2024 | kingkelvin
In calibration menu - I see coarse measurement of z unit offset, z-unit offset, measure hydra camera z level, coarse adjust hydra tool offsets, and measure hydra tool lengths 1 - 8 - would it be any of these that I should run?
Electronics Forum | Thu Mar 28 14:28:26 EDT 2024 | kingkelvin
We have MY9 - when it changes hydra tooltips - most of the time it makes a small "hitting" type noise - with error F-MOT MOVESLOWMOVE HYDRA Z/205 - however you can just hit continue and it will always change the tools and finish the board - I've un-i
