Electronics Forum | Thu Jul 02 08:27:46 EDT 2015 | sssvajunas
Maybe someone know where company can buy MYDATA FLEX 24mm feeders(only used)? Becouse I found only Flex magazines, 32mm, 44mm feeders but not 24mm.
Electronics Forum | Sat Jul 04 03:00:21 EDT 2015 | padawanlinuxero
i dont work for them but i get a lot of stuff of MYDATA with them IBE SMT Equipment 318 Corporate Woods Drive Magnolia, Texas 77354 United States Toll Free: (800) 353-6942 Office: (281) 259-9660 Fax: (281) 259-886 cheers!!!
Electronics Forum | Thu Jul 02 09:30:28 EDT 2015 | mrsamiemiller
Good morning! You can try: Feeder Frenzy 131 Burke Street Nashua NH 03060 USA (603) 594-4229 Voice (603) 594-0554 Fax FeederFrenzy.com I hope you have a wonderful day!
Electronics Forum | Fri Aug 12 20:09:41 EDT 2005 | dorklover664
First off I would like to say it's good to be back. I haven't been working production and I'm really glad to be back. Next... I am looking for either a used MyData flex or 12/16 magazine. Cheap is the key (new company has less then 50 employees)! We
Electronics Forum | Wed Sep 30 06:25:14 EDT 2015 | strongbyte
I am looking to buy a Flexible magazine for a Mydata TP9-UFP I have seen both TMCFlex and TMDFlex magazines available, does anybody know the difference between the two and whether they are compatible with my machine. I spoke to a Mycronic engineer
Electronics Forum | Wed Sep 30 08:29:15 EDT 2015 | johanbergstrom
The difference between TMC Flex and TMD Flex is about the ability to feed component tape with deep pockets for larger components. The TMC have a rather low passage for embossed component tape. While TMC Flex is limited to a maximum tape depth of 7,5
Electronics Forum | Thu Jun 20 17:40:03 EDT 2002 | pjc
Depends on which Assembleon machine, aye? The "GEM" line, Topaz & Emerald, stuff is Yamaha- Japan, which I consider more along the lines of Juki and i-Pulse (Tenyru/Yamaha), and maybe Samsung. The "Power" line, ACM & FCM, on the other hand is pure Du
Electronics Forum | Fri May 14 08:30:52 EDT 2004 | pjc
For any application- high-mix, low volume to low-mix high-volume: J.O.T. Automation board handling MPM UltraFlex 3000 printer CyberOptics SE300 3D post print inspector 2x Mydata Synergy II w/ Linear Magazines and Agilis feeders CyberOptics Flex
Electronics Forum | Thu Jan 13 03:38:18 EST 2005 | Base
Hi Grant, You say your design are increasingly using more passives. Do you mean you're using more and more components per board or is it only the ratio passives/IC's that is shifting? And are you also increasing volume or is it just the component-co
Electronics Forum | Wed Jan 12 14:47:09 EST 2005 | gregp
This will always be the case with in-line spindle machines that rate their cph based on unreal conditions. Flexible placement machines with different head designs will perform better (closer to advertised) and are truley more flexible because you do
