Electronics Forum | Sun Dec 04 16:54:52 EST 2011 | andersenequipment
I have a mydata tp-11, crap hard drive, When I look to replace the hard drive with another, the machine ask me for a password or passcode. Anyone help?
Electronics Forum | Sat Dec 16 18:27:52 EST 2006 | bvdb
We've been using the MCS-16F computer with a Fuji IP-1 for about 9 months and wonder what the "Hard Disk Maintenance" feature does. We have no documentation on this feature. Best Regards, Bert
Electronics Forum | Sat Dec 16 20:28:59 EST 2006 | Ola
How old is this machine? What is the current level of the Application s/w and OS? /
Electronics Forum | Sat Dec 16 22:43:56 EST 2006 | Ola
Hi, If I remember correctly (it has been about 15 years since i worked with one of these.)The old MCS machine is based upon a Motorola 6800/68000-series Micro processor and the operating system is OS/9 from Microware Systems Corporation. This was a r
Electronics Forum | Sat Dec 16 21:41:19 EST 2006 | bvdb
I'm at home right now but remember that the MCS-16F boots up saying V2.3. The IP-1 is a 1986 machine but the MCS-16F was purchased used as a replacement to one that didn't work. The vintage is unknown. Tomorrow is Monay and I'll see if there is an
Electronics Forum | Mon Sep 03 21:49:26 EDT 2018 | aemery
Maybe your CMOS battery is dead! On some of these old system once the battery is drained the CMOS settings are lost, this would include the correct setting for detecting the hard drive and I doubt there is an auto detect . Try turning on the machine
Electronics Forum | Wed Mar 21 09:33:05 EDT 2007 | chrisgriffin
Every time I had a disk utility take that long, the hard drive was pretty much not usable. Could be write errors or bad sectors on the drive.
Electronics Forum | Sun Dec 04 16:40:32 EST 2011 | andersenequipment
I am replacing a hard drive on a mydata tp11. it ask me for a passcode??? does anyone know how to clear this out? it has the original stuff in it. Please advise.. Tom
Electronics Forum | Fri Feb 11 15:50:51 EST 2005 | Grant
Hi, We are looking at selling the machine in mid April, May time frame. We are selling the machine, all feeders etc. But it's located in Australia, so a bit hard to ship to most locations. If your interested, please email grantpetty@blackmagic-desig
Electronics Forum | Wed Mar 25 18:34:34 EDT 2020 | spoiltforchoice
> What about designators? Using gerbers to program > a pnp machine was always a last resort to be done > only after much complaining and begging for > proper CAD data. Back in the day I used UniCAM to > program a mydata. After gett
