Electronics Forum | Thu Feb 20 13:16:15 EST 2014 | rgduval
Hi, Brendan, It sure sounds like it to me. But, with the Z axis, there could be one other thing to check. On my old TP, there were z-locks...two pistons that pointed sideways around the head travel. Initializing the z-motors did not move the z-
Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Electronics Forum | Wed Nov 21 13:42:12 EST 2007 | etienne
To answer your question: During my experience with Topaz machines, we had to replace 4 Heads on different occassions with different operators involved. Also I encountered several Head crashes with Eclipse machines. To buy such replacements here in Ma
Electronics Forum | Fri Nov 30 00:14:36 EST 2007 | vinitverma
ET, With due regards to your '7 years experience', I must say that in my 11 years experience, this is the first time I am hearing about head replacement on a Topaz. On the Eclipse it is easy for an operator to make a mistake by moving the head manua
Electronics Forum | Tue Feb 03 15:28:36 EST 2009 | kpm135
I agree, I'd try placing them with the midas or z-fi head depending what you have. Try using the mechanical centering in the zero angle with a low strength to move it straight. You'll probably have better luck finding a tool that will work on the hea
Electronics Forum | Sat Nov 17 10:24:17 EST 2007 | etienne
Hi, I can give my opinion in this topic since I worked with both machines. To say the truth, I would recommend neither machine. First of all, operating software is much quite the same for both machines. The TP9 is true that has a larger footprint ov
Electronics Forum | Mon Nov 19 15:21:44 EST 2007 | wayne123
I was not trying to imply that you didn't know how to run these machines I was simply saying that alot of problems that people may encounter can be solved with operating them correctly, I am sorry if you took offense to this, I too have performed all
winsouce.jpg)
