Electronics Forum | Thu Mar 28 14:28:26 EDT 2024 | kingkelvin
We have MY9 - when it changes hydra tooltips - most of the time it makes a small "hitting" type noise - with error F-MOT MOVESLOWMOVE HYDRA Z/205 - however you can just hit continue and it will always change the tools and finish the board - I've un-i
Electronics Forum | Mon Apr 08 15:07:56 EDT 2024 | tey422
To me, it seems like there are slightly XY offset. Hydra might be able to pick up the tips, but not all the way securely attached to the hydra tubes. So, when the tips put back are not fully seated, which causing the tool stick inside the bank. You
Electronics Forum | Wed May 08 11:20:24 EDT 2013 | amelby
Thanks for the info on the Hydra tubes that will be helpful. I found the answer from one of the Mydata techs. The Camera needs the hydra head to go slower then 1.9m/sec and the setting was at 1.8m/sec. They found out that even if the machine was set
Electronics Forum | Fri Feb 21 17:12:43 EST 2020 | SMTA-Alex
Have you performed the maintenance? It might need grease, or there might be excess old grease, that's putting more friction on the Hydra Z. Check if there might be interference from the vacuum tubes or wires.
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Mon Apr 08 14:07:25 EDT 2024 | kingkelvin
Hello all - so I got in the calibrate plate for hydra tool offsets - it completed the calibration - I then installed the first row of white tips with the menu - and the machine still does same thing it puts the tips away but makes a hitting type nois
Electronics Forum | Wed Sep 21 12:12:24 EDT 2005 | vikkaraja
HI there, I have a problem with my TP11 HYDRA HEAD. It is not picking up parts from the magazine. I have been working with Mydata on this issue, but I have not had much success so far. So far I done the followings:ran vaccum test, tube height, and H
Electronics Forum | Thu Dec 28 20:46:49 EST 2023 | padawanlinuxero
I was use to work with the machine but it has being several years since I had one in my hands, but i got the same error message, I kinda remember there are some sensors in the top part of the hydra try to see if theres dirt or something not letting t
Electronics Forum | Mon Apr 08 18:16:20 EDT 2024 | mistrthou
We had a Mycronic tech in adjusting rings to get us within spec. He was saying the emitter/receiver board at the top and the tubes themselves can go bad. Between that and having weak latches, we're looking at a refurbished unit. But we're rocking a M
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
| 1 |
winsouce.jpg)