Electronics Forum | Fri Jan 19 05:46:59 EST 2018 | ivammendes
MYDATA MY9E: Hydra's pipe can't stop the vacuum during assembly. The problem ocurre just in only one pipe, the number 5. The tool picks components but doesn't drop it. Can the problem be in the unit vacuum?
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Electronics Forum | Tue Feb 03 14:24:10 EST 2009 | pms
Don't pick them with the Hydra !!!!!1111111
Electronics Forum | Fri Jan 19 08:23:26 EST 2018 | ivammendes
Our supplier said the same. I thought it could be anything more simple. Anyway, he will send me another block to replace and see if works. Thank you for answer.
Electronics Forum | Fri Jan 19 09:36:06 EST 2018 | emeto
In my opinion save the old block and see how hard is to replace one if you have problems in future. I suppose it will be fixable.
Electronics Forum | Fri Jan 19 08:10:03 EST 2018 | emeto
It should be one of these latches that got stuck in position. I had a similar problem(my200 machine) the other way around - my stays closed so I don't get any vacuum. The problem is that the whole block of latches should be replaced(on a my200 machin
Electronics Forum | Tue Feb 03 10:44:56 EST 2009 | lmartenson
We have been having problems placing a domed LED with a Mydata HYDRA. The pocket that the part comes in seems to have some slop causing the part to be picked crooked. We have been playing around with different custom tools. Has anyone had similar
Electronics Forum | Tue Feb 03 15:28:36 EST 2009 | kpm135
I agree, I'd try placing them with the midas or z-fi head depending what you have. Try using the mechanical centering in the zero angle with a low strength to move it straight. You'll probably have better luck finding a tool that will work on the hea
