Electronics Forum | Thu Feb 20 13:16:15 EST 2014 | rgduval
Hi, Brendan, It sure sounds like it to me. But, with the Z axis, there could be one other thing to check. On my old TP, there were z-locks...two pistons that pointed sideways around the head travel. Initializing the z-motors did not move the z-
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Fri Apr 10 09:59:13 EDT 2020 | spoiltforchoice
> We unfortunately use GERBER data to digitize <BR> > boards more than any CAD. We are CM and many of <BR> > our customers do not provide CAD. With some <BR> > Legacy products, we still use 274-D Gerbers
Electronics Forum | Tue Dec 21 17:15:49 EST 2021 | vtdivtecs
yeap I was able to figure it out and avoid my head being on a stick anywhere. if you log out of tpsys and into hw config you can turn off the hydra head there, then unplug the hardware and the machine will run. if you just disable it inside tpsys t
Electronics Forum | Thu Jul 24 09:30:44 EDT 2008 | 18424
Is this a used machine or did you purchase it new?
Electronics Forum | Thu Jul 27 07:38:16 EDT 2006 | cyber_wolf
Have you considered calling Mydata tech support ?
Electronics Forum | Mon Jul 31 07:09:20 EDT 2006 | ev
Yes .... I have spoken with Mydata tech support several times.
Electronics Forum | Tue Jan 04 10:06:51 EST 2011 | ev
Thanks anyway.
Electronics Forum | Thu Dec 30 16:10:37 EST 2010 | ev
Seasons Greetings to all. Here's hoping for a great 2011. I have a Mydata TP11-UFP that won't initialize on start up. Hence we can't run production. Has anyone seen this problem? Do you have any suggestions.
winsouce.jpg)
