Electronics Forum | Wed Apr 01 12:16:46 EDT 2020 | proceng1
We use CircuitCam extensively, but not for MYDATA. What exactly is the issue you are seeing? Do you have the MYDATA Export module from Aegis?
Electronics Forum | Tue Jun 08 22:30:05 EDT 2021 | vtdivtecs
So I am having a little trouble with my mydata MY19. its an older machine picked up used and its had its quirks. recently we tried to start adding electrical verification to our workflow, and had to disable it as we were getting intermittent bad pa
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Fri Apr 10 09:59:13 EDT 2020 | spoiltforchoice
> We unfortunately use GERBER data to digitize <BR> > boards more than any CAD. We are CM and many of <BR> > our customers do not provide CAD. With some <BR> > Legacy products, we still use 274-D Gerbers
Electronics Forum | Thu Apr 09 20:18:31 EDT 2020 | jlawson
Can not speak for CircuitCam is made by Aegis Software I veliveve sound like need to get understanding of how tool is supposed to work to extract-create centroid positions. Using Gerber Only is a pattern match and cacluate logic process - ie make pac
Electronics Forum | Tue Jun 19 12:57:35 EDT 2007 | rgduval
I don't recall seeing a battery anywhere on the boards on the magazines. I'd give MyData a call, and ask them about it. They're pretty good on the phone. Might be the battery used for electrical verification . Good luck!
Electronics Forum | Wed Jun 20 07:59:56 EDT 2007 | avalancher
The issue you are seeing is in fact the Battery that is in your machine. It looks like a motorcycle battery. It is usually located somewhere in or around your power supply. It should be reading an output of 18V. This battery is used in the event of a
Electronics Forum | Tue Jun 19 11:28:10 EDT 2007 | kpm135
I am fairly new to the MYData machine. The TP11 we have just started generating the following error: W-MIPR-20:System voltage BATTERY measured 14.59V (outside limits). After talking with the operators and reading the manual I believe the problem may
Electronics Forum | Wed Jun 27 18:10:34 EDT 2007 | kpm135
Just thought I'd let you know the problem was the Batteries. There happened to be three 6 volt 10 Ah batteries hooked in series that were no longer holding voltage. Also we ended up replacing the MI board because there was a fried component on it. Do
Electronics Forum | Tue Jun 19 16:19:34 EDT 2007 | bk
There are no batteries in mydata magazines. This problem means your voltage is outside it's allowed range. In this case I think it's the 15 volts. If you open up the bottom of the machine and pull out the carriage you'll see a rectangular box that ho
