Electronics Forum | Fri Jun 17 10:45:46 EDT 2005 | geb
What is the rule for setting the lighting level for fiducials. There is an inner and outer lighting ring, both can be set independantly on a scale of 0 to 100. It seems to be just trial and error getting it to work on different products, which is a s
Electronics Forum | Tue Sep 22 16:39:10 EDT 2009 | rmitchell
Hi, We are getting a E-Hydra-1 Frame grabbing failed on caps and resistors and also a Light Curtain trigger X wagon. I spoke with mydata and they indicated the light curtain might be getting set off and causing the frame grabbing failure. I cleane
Electronics Forum | Mon Aug 20 07:31:26 EDT 2007 | dilogic
We have GSM1 running on USOS V1.4.14. Is there a way to change default light levels for PEC (down looking camera) during feeder teach? Whatever I tried, it is always set to some default level... - Dejan
Electronics Forum | Wed Sep 23 08:19:52 EDT 2009 | rgduval
Check to see if there's a loose cable, or something, that's randomly setting off the light curtain. We occasionally have that problem with some of our flex or 12/16 mags in our TP9, where the tape take up clip is loose (nothing in that feeder) and i
Electronics Forum | Mon Oct 03 12:17:18 EDT 2005 | jdengler
Another problem I have seen on CP's is mixing suppliers on the Anti-Marking Illumination Disks. Some after market suppliers disks do not reflect the light the same as Fuji's disks. It is nearly impossible to get the lighting level good enough for r
Electronics Forum | Fri Mar 18 14:27:29 EST 2005 | pmd
Hold on, MyData can place no component and not detect error if the minimum and maximinum settings in the centering phase are within the mesurement of the tool it'self. Especially if the levels are down between the jaws. For insurance make sure the to
Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already
Electronics Forum | Wed Apr 02 09:56:59 EDT 2008 | patsama_n
Every time to create new AOI program we must manual set at bright lighting level for each component. then this case we think the parameter of AOI setting it not concern for this problem due to the golden board that we use to confirm machine before st
Electronics Forum | Mon Aug 17 17:01:31 EDT 2020 | rgduval
+1 to what Sr. Tech said. I'd also add that you could have some uneven deterioration of the centering jaws. Check by doing a couple of things (this will help check if the tool/tip is bent/deteriorated as well): 1. Turn off mechanical centering, and
Electronics Forum | Sun Apr 25 21:01:57 EDT 2010 | m79d
Hi all our IP1(1993)is not reading the board fiducials, the light comes on at the fid camera and stay on and the machine just hangs. Need to press the emergency stop button to go any further and screen says 'mark not readable'. None of the bulbs h
winsouce.jpg)
