Electronics Forum | Tue Jun 08 22:30:05 EDT 2021 | vtdivtecs
So I am having a little trouble with my mydata MY19. its an older machine picked up used and its had its quirks. recently we tried to start adding electrical verification to our workflow, and had to disable it as we were getting intermittent bad pa
Electronics Forum | Fri Dec 04 13:08:57 EST 2009 | pms
My9 = 9 magazine slots. My19 = 19 magazine slots. That being said. The number after th "MY" is the number of magazine slots. The "differances" will be in software version, upgades, like vision (linescan etc), hydra, tables, tools, tray exchangers,
Electronics Forum | Thu Jan 05 12:33:30 EST 2017 | rgduval
If you haven't resolved this yet, I think you're going to want to go to either the part or the package (I'm not sure which one off hand), and make sure that the hydra heads/tools are selected for placement. You'll also want the vision set to the lin
Electronics Forum | Fri Dec 04 09:09:46 EST 2009 | bandjwet
We are considering purchasing an MY-19 refurbished from the factory. We were not initially looking at this model but it became available. Are there any issues with this model. (We already have an MY-9 and are familiar with the MYDATA and their suppor
Electronics Forum | Wed Feb 12 14:14:42 EST 2020 | alvarez94
I am running a MYDATA MY19 machine.the problem is that the first 2 hours after turning on the machine it does not work throwing the following error: "transducers do not agree". After approximately 1 or 2 hours the machine starts working normally. T
Electronics Forum | Tue Jul 05 22:10:42 EDT 2022 | nellegaard
I am currently trying to setup a used MyData My19 machine and am currently having issues installing tools getting errors such as failed to pick up tool and Z force sensor failed. I have tried to clean the tool pickup area as well as clean and lubrica
Electronics Forum | Wed Feb 12 14:39:23 EST 2020 | SMTA-Alex
Do you have a photo of the actual error?
Electronics Forum | Wed Feb 12 14:44:56 EST 2020 | alvarez94
Thanks for responding, this is the photo of the error that appears on the screen
Electronics Forum | Wed Feb 12 14:53:21 EST 2020 | SMTA-Alex
Looks like an X-belt problem. is it tensioned correctly, not too loose or too tight? Or the X motor is acting up.
Electronics Forum | Wed Feb 12 15:15:10 EST 2020 | SMTA-Alex
Not really, just eyeball. Does it look too loose or feel too tight. Is it lubricated properly, is there enough grease on the sprockets? Also, check the ribbon cables. They might be damaged.
.gif)
winsouce.jpg)