Electronics Forum | Mon Aug 31 07:06:20 EDT 2020 | bukas
did you try to unslot all computer boards (both PC and machine)and put them back? sometimes they loose contact and make wacky errors...
Electronics Forum | Fri Aug 28 12:46:04 EDT 2020 | inspiredmorris20
Greetings all, my cp45 pnp machine is down this morning, gives me the code 0002 (front EME switch pressed). operator said they did not E-Stop, reset the unit and reboot the S/W a few times. the code pops up as soon as the software loads. I can turn
Electronics Forum | Fri Aug 28 17:24:28 EDT 2020 | stephendo
Did you check all the voltages and fuses? The second worst is when a machine is down for a while and it ends up being something basic. The worst is when it started as something basic and someone introduces a new problem. Also could there be any opti
Electronics Forum | Mon Aug 31 15:39:18 EDT 2020 | jmelson
Yes, the rightmost VME board is the IO_DPRAM, and it also handles the front panel buttons and E-stop inputs to the computer(s). So, reseat the connectors on the front of that board. Also, there may be an interface board on the bottom left (called C
Electronics Forum | Mon Aug 31 03:24:54 EDT 2020 | jmelson
I don't know this exact machine, but it likely has similar logic to some other Samsung machines. The E-stop buttons have TWO sections. One shuts off the "main start" button, the other informs the computer that the button has been pressed. If you d
Electronics Forum | Thu Mar 21 22:27:13 EDT 2013 | padawanlinuxero
Hi ! I have the same problem with some rolls of tape, we did check the feeder magazines in our mydata machines but turns out the problem is with the plastic cover sometime it comes with just too much adhesive that the feeder magazine cant peel the p
Electronics Forum | Wed Jul 20 22:59:34 EDT 2016 | ttheis
I had something similar to this on a different type of machine but it turned out to be a broken wire terminal connector at the switch causing intermittent connection. Often with safety circuits they are kept high and brought low or interrupted to dis
Electronics Forum | Wed May 06 17:05:43 EDT 2020 | bobpan
Did you release the emergency key and then press stop and reset twice on the machine?
Electronics Forum | Mon Aug 22 12:25:15 EDT 2016 | mosborne
Ours does the same thing. I was told to update the software to fix the problem, but we just upgraded to a new machine.
Electronics Forum | Fri Nov 30 00:14:36 EST 2007 | vinitverma
ET, With due regards to your '7 years experience', I must say that in my 11 years experience, this is the first time I am hearing about head replacement on a Topaz. On the Eclipse it is easy for an operator to make a mistake by moving the head manua
