Electronics Forum | Wed Nov 15 10:40:52 EST 2006 | pms
To bad Steve, CircuitCam is good stuff. On a side note. Large programs on MyData's. We load the machine with all the mags it will handle. Run the program, take out mags that the program has used, insert other mags with the incompleted parts, run pro
Electronics Forum | Thu Apr 28 11:13:33 EDT 2005 | cyber_wolf
We currently have Fuji's(IP3's included) and Mydata's in our SMT area , so training is not an issue. The reason I was thinking of an IP3 is because they seem to be available for 50K or so. We cannot afford to loose any mag positions on our Mydata's t
Electronics Forum | Mon Mar 07 11:19:13 EST 2005 | cyber_wolf
Another thing : Make sure that there are no other mags plugged into the machine while you are trying to trouble shoot slot 3. I have seen shorted vibratory ID chips mess up other magazines up in different slots. For instance : a shorted vibe in slo
Electronics Forum | Thu Mar 24 17:36:31 EST 2005 | Grant
Hi, Yes MYDATA vibration feeders are a nightmare, but you might want to check the feeder. We had one that would vary a lot, and it never seemed to be able to be set to the right vibration level for consistent feeding. It turned out to have a problem
Electronics Forum | Thu Jul 18 17:38:27 EDT 2019 | rgduval
Not swapping out feeders....swapping out magazines. It only works well if you have enough extra mags to load all the feeders on. And is a viable solution if your position limited on your machine. Before the advent of Aegis feeders for My machine
Electronics Forum | Thu Dec 23 12:32:57 EST 2004 | OverTheHill
All right all you Mydata techies. Here's the scoop. My old TP9 seems to be damaging (bending) it's A12 and A13 tools way too frequently. Like 4 tools in the last month. It appears the tool is colliding with somthing. My perfect operators SWEAR there
Electronics Forum | Mon Jun 26 10:55:34 EDT 2006 | cyber_wolf
Do you have a login for the support section on the Mydata website ? If not, get one. Click on MYtech, then click the article named: "Simple feeder care reduces reject rate! The component separator spring" We run alot of 0402's on the TM8FC mags wit
Electronics Forum | Thu Jul 19 06:49:38 EDT 2007 | cyber_wolf
Chris, Are you sure about the joystick trackball statement? He said he is seing "bounce" when he steps through placements and when he trims mag positions. That would indicate a issue with the small x-mot system to me.
Electronics Forum | Fri Feb 15 08:31:03 EST 2013 | cyber_wolf
I believe you need 1.5.13 or higher if I'm not mistaken to run the mags with the button upgrade. There is no way around it that I am aware of.
Electronics Forum | Mon Feb 13 11:02:05 EST 2006 | Alan
Hi Grant, Does the Flex mag have the corect pal chip in it? Some of the early Flex mags had tm8 pal chips in them. On the machine this did not have much of an effect (it did at one time allow you to have the hydra pick from the flex because the mach
winsouce.jpg)