Electronics Forum | Wed Mar 16 00:10:46 EDT 2022 | SMTA-64387687
Yes, your TM magazines will work. However, you will lose some performance.
Electronics Forum | Tue Jun 19 11:28:10 EDT 2007 | kpm135
I am fairly new to the MYData machine. The TP11 we have just started generating the following error: W-MIPR-20:System voltage BATTERY measured 14.59V (outside limits). After talking with the operators and reading the manual I believe the problem may
Electronics Forum | Mon Mar 07 09:44:49 EST 2005 | anonomous
The machine sees a magazine, but with wrong number. somehow one (maybe more) wire from the magazine bus does not reach slot 3, as the other slots work, there is probably not a short, as the magazine bus work for other slots, the problem is probably i
Electronics Forum | Thu Jul 18 17:38:27 EDT 2019 | rgduval
Not swapping out feeders....swapping out magazines. It only works well if you have enough extra mags to load all the feeders on. And is a viable solution if your position limited on your machine. Before the advent of Aegis feeders for My machine
Electronics Forum | Fri Apr 01 01:26:17 EST 2005 | Marv
A couple of things.. 1) The problem is more than likely on the magazine board itself (TC2), most likely the pal chip that stores the serial number and feeder information (you could swap this with a working magazine to verify) 2) The magazine connecto
Electronics Forum | Fri Sep 23 09:25:46 EDT 2005 | Base
Hey Greg, As you already pointed out yourself: unless you can do away with covertape pickup-spools (or can figure out a way to empty them without loosing tension on the covertape) your feeders will not be suitable for several consecutive splices. S
Electronics Forum | Wed May 09 10:39:03 EDT 2001 | davef
The two first level cuts at comparing placement machines are: * Placement rate * Range of component capabilities This boils-down approximately to machine price. Virtually, everyone's feeders are priced similarly. Go to "Circuits Assembly" magazine
Electronics Forum | Tue Aug 09 13:58:24 EDT 2005 | Cmiller
I saw a Mydata demo and it seems like it would be pretty easy to pull a magazine back a few inches then tip it up into the head. I assume this would cause catastrophic damage. I was told this has never happened in North America. Which means it must h
Electronics Forum | Wed Aug 25 14:53:10 EDT 2004 | smokejumper
TM8 Magazines step 4mm min. You need a TM8FC or Agilis. You can make a tray and pick from strips of tape too.
Electronics Forum | Thu Dec 23 13:38:25 EST 2004 | clampron
Over The Hill, Sounds like you may have an incorrect height specified on a package causing the tool to slam into the board. The most likely cause is removing a magazine while the machine is running but I too have perfect operators who NEVER do that.
.gif)
