Electronics Forum | Thu Feb 13 09:52:03 EST 2014 | rgduval
Start by getting into the maintenance menu, and manually installing the Servo program for all MOTs. If they install fine, you can check the Z-motor while you're in the maintenance menus. Make sure that the z-locks are unlocked before checking the
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Thu Feb 20 13:16:15 EST 2014 | rgduval
Hi, Brendan, It sure sounds like it to me. But, with the Z axis, there could be one other thing to check. On my old TP, there were z-locks...two pistons that pointed sideways around the head travel. Initializing the z-motors did not move the z-
Electronics Forum | Fri Nov 30 00:14:36 EST 2007 | vinitverma
ET, With due regards to your '7 years experience', I must say that in my 11 years experience, this is the first time I am hearing about head replacement on a Topaz. On the Eclipse it is easy for an operator to make a mistake by moving the head manua
Electronics Forum | Mon Nov 12 13:35:34 EST 2007 | dyoungquist
MyData TP9s Work well in high mix applications because change over time from 1 job to the next can be done in as little as 15 minutes if you have the right mix of magazines/feeders. Component placement rates vary depending on which component you ar
Electronics Forum | Mon Nov 19 13:27:21 EST 2007 | etienne
People not knowing how to use them...surely not my case........I have worked for more than 7 years with a Topaz and always performed the maintenance and repairs on my own without the assistance of field service engineers!!! Please respect cause I kno
Electronics Forum | Mon Nov 19 15:21:44 EST 2007 | wayne123
I was not trying to imply that you didn't know how to run these machines I was simply saying that alot of problems that people may encounter can be solved with operating them correctly, I am sorry if you took offense to this, I too have performed all
Electronics Forum | Sat May 07 11:42:10 EDT 2005 | mrmaint
Have alot of exp. on both mydata and philips/assembleon. My preference would be the assembleon. Maintenance is light and they run forever. New software on assembleon is excellant. Customer support is one of the best i have delt with. mrmaint
Electronics Forum | Wed Dec 19 11:16:53 EST 2001 | bmulcahy
Hi, Just to confirm what is being said by everyone else. Good software and programming. Linux based rather than NT so people are less inclined to 'tinker '. Maintenance and breakdowns are easy to deal with . Breakdowns happen rarely and in 3 years I
Electronics Forum | Fri Mar 24 15:10:20 EDT 2023 | tey422
I worked with 7 years of Mydata & another 8 years with Juki. Most of the small issues are avoidable if you do your maintenance right. From normal wear and tears, I would say Mydata would be more frequent breakdowns than Juki. For Juki, I agree with
