Electronics Forum | Fri Oct 08 14:27:54 EDT 2004 | M_Oniah
Many problems with the APS feeders and controller. We replaced it with Mydata. Much better.
Electronics Forum | Thu Feb 13 09:52:03 EST 2014 | rgduval
Start by getting into the maintenance menu, and manually installing the Servo program for all MOTs. If they install fine, you can check the Z-motor while you're in the maintenance menus. Make sure that the z-locks are unlocked before checking the
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Thu Feb 20 13:16:15 EST 2014 | rgduval
Hi, Brendan, It sure sounds like it to me. But, with the Z axis, there could be one other thing to check. On my old TP, there were z-locks...two pistons that pointed sideways around the head travel. Initializing the z-motors did not move the z-
Electronics Forum | Mon Nov 12 13:35:34 EST 2007 | dyoungquist
MyData TP9s Work well in high mix applications because change over time from 1 job to the next can be done in as little as 15 minutes if you have the right mix of magazines/feeders. Component placement rates vary depending on which component you ar
Electronics Forum | Fri Nov 30 00:14:36 EST 2007 | vinitverma
ET, With due regards to your '7 years experience', I must say that in my 11 years experience, this is the first time I am hearing about head replacement on a Topaz. On the Eclipse it is easy for an operator to make a mistake by moving the head manua
Electronics Forum | Mon Nov 19 13:27:21 EST 2007 | etienne
People not knowing how to use them...surely not my case........I have worked for more than 7 years with a Topaz and always performed the maintenance and repairs on my own without the assistance of field service engineers!!! Please respect cause I kno
Electronics Forum | Mon Nov 19 15:21:44 EST 2007 | wayne123
I was not trying to imply that you didn't know how to run these machines I was simply saying that alot of problems that people may encounter can be solved with operating them correctly, I am sorry if you took offense to this, I too have performed all
Electronics Forum | Tue Aug 20 07:35:04 EDT 2002 | bmulcahy
Hi, I guess you a looking for a manual x-y table with a vacuum pick up such as SMT6000 from OK industries. I presume these are still being made-- We use one successfully at the end of a Mydata machine to place low volume components which we cannot j
Electronics Forum | Wed Apr 12 19:57:55 EDT 2006 | Mydata User
Has anyone had luck with Mydata US web contact forms? There are forms on their US website that allows contacting departments directly, but nobody ever responds. Does anyone ever get responses back?
