Electronics Forum | Tue Feb 08 22:04:34 EST 2005 | davef
Tough to say. Can you accept the loss of strength of your solder connection if upto 2% of the solder is affected? * Lead and bismuth alloys can form a eutectic composition of Bi52Pb32Sn16 in the grain boundaries. * Melting point of the eutectic all
Electronics Forum | Fri Jul 19 13:05:56 EDT 2002 | pjc
It has been release by Mydata. I haven't used it yet.
Electronics Forum | Wed Oct 19 19:25:02 EDT 2022 | smtusa
Are the TM feeders ok for parts bigger than 0402? No major loss? The mydata machines I am looking at seem to have pretty high mispicks compared to other solutions on the counter.
Electronics Forum | Wed Apr 26 12:02:15 EDT 2006 | jemills
Thanks very much for your input Russ.Nice to jar the memory and ensure all bases are covered.Don't have the Bar code interface so bar code is a future-future demand. JEM
Electronics Forum | Wed Oct 24 07:33:44 EDT 2018 | tech1
when the machine initiates the last move it does is in the Z axis. If memory serves me, during the last Z move it drives down and measures the stroke, if the lower solenoid is not fully retracted the axis measures the wrong travel limits. Hopefully t
Electronics Forum | Mon Dec 21 11:28:47 EST 2009 | lynn_norman
We used Loctite 3609 and never had problems. If memory serves me isn't 3606 a screen print adhesive? First thing I would check is the cure profile of the adhesive. If it doesn't develop full adhesion, could be problems. Nuther question is are you
Electronics Forum | Thu Mar 28 17:13:11 EDT 2024 | tey422
It's been long time, me memories are fading away. If I remember correctly, you would need small flat surface plate or something to cover up the "linescan" hydra camera, so from the reflections value then it can calculates the actual height "lowest"
Electronics Forum | Thu Jul 18 11:57:19 EDT 2002 | pjc
For component loss that cannot be accounted for by the placement machine's computer I would have the operators collect all loose components from the feeder setup area and in and around the placement machines after each product batch run. This is cert
Electronics Forum | Wed Oct 19 21:51:24 EDT 2022 | rgduval
The only time we dealt with "major" loss related to the feeders was when they were out of maintenance. Kept in good shape, sure there's loss; but, I never considered it to be major. But, that is subjective, of course. In the end, in my mind, it
Electronics Forum | Tue Mar 04 17:17:29 EST 2014 | catsem23
Hi I'm trying to pick and place a lot of sod523 components with a mydata my12. I'm using C14 standard tool and Hydra tool H01. For some reason no matter what I try to do when the head picks the component with the C14 tool the machine emergency stops
