Electronics Forum | Thu Feb 10 14:56:50 EST 2005 | jimdugan
The Mydata machine is a very good high mix low volume machine. If you buy from Mydata you will be better supported, than if you buy from a broker. I would recommend you buy the newer My series machine. The TP machine was a good machine but the My ma
Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Tue Feb 03 15:28:36 EST 2009 | kpm135
I agree, I'd try placing them with the midas or z-fi head depending what you have. Try using the mechanical centering in the zero angle with a low strength to move it straight. You'll probably have better luck finding a tool that will work on the hea
Electronics Forum | Tue Feb 18 14:37:41 EST 2020 | bk
What type of head do you have on your machine a midas head or a zi-fi head? Regardless of which you do have I would make sure that the head is clean where to tools go into the head. Use a soft swab or something similar so you do not damage the z forc
Electronics Forum | Tue Dec 21 12:28:11 EST 2021 | vtdivtecs
hey all, I had a comically bad failure yesterday while working with my pick and place, a part got dropped at exactly the wrong moment and flung a bracket up into the tool path, severely damaging the hydra controlboard that is next to the x camera. T
Electronics Forum | Thu Sep 13 06:26:01 EDT 2007 | chrispy1963
Yeah Sr., MyData is definately proud of their parts which shows in their pricing. We use outsourced parts where ever available. Belts for Ywagon tables, conveyor drive belts, ect.... We finally got a break on the tooling though! Finally found a way
Electronics Forum | Thu Aug 30 20:58:50 EDT 2007 | ronsou
Hello all Has anyone ever upgraded their machine from the Hydra camera to the linescan camera? I was wondering what your cost was. I recently requested a quote and almost fell out of my chair when I recieved it. Thank Ron
Electronics Forum | Wed Sep 12 15:00:53 EDT 2007 | cyber_wolf
Never did the Linescan upgrade. Incidentally I recently needed to rebuild a vacuum pump. Pump rebuild kit consist of a coupling a couple rubber mounts and the membranes. Cost 495.00
