Electronics Forum | Mon Oct 22 08:27:49 EDT 2018 | filipblad
Hi, We're having issues with our mydata tp9 pick'n place. It doesn't go all the way down on the tool, so it can't pick it up or install it. The fault code I get when trying to install tools is F-TLMN-18: Can't reach tool bank. Any ideas? I've comp
Electronics Forum | Fri Mar 20 18:04:59 EDT 2009 | clearblue
We are having the same error message (F-Axis-23: X-Axis transducer ch.1 PTP value too low) on our TP9-2U that you had in 2007 with your TP9 2. I am hoping your memory is excellent, you are still at this email address, and you were able to fix the ma
Electronics Forum | Tue Jul 22 09:12:58 EDT 2008 | chiptargets
Hi, I posted a similar message yesterday, but I believe it did not make it through properly. I apologize. We have an error while trying to perform Initiate Hardware test. The error was "F-MOT1-25/205:MOVZ: Motorspeed Out of Control". The error, ho
Electronics Forum | Mon Sep 21 00:11:14 EDT 2009 | darrenj
We have a TP9 with a centering motor issue. (TPSYS Ver 2.5.3) The error message F-MOT-SETDYN C/3 Upper endpoint outside limits is shown during C-motor initiation. I've looked in the service program and also the parameters in TPSYS but can find no m
Electronics Forum | Tue Feb 28 12:29:20 EST 2012 | richieoreilly
Hi All, I am currently looking at purchasing an SMT machine with 01005 and flip chip capability, We have a limited budget but have found some machine which may suit. Mydata MY100LX10e Fuji NXT, 2nd hand 2007 vintage, Yamaha YS12F Do any of you ha
Electronics Forum | Wed Jun 27 12:51:53 EDT 2012 | cyber_wolf
You can leave the booster in the original position and mount two small fans directly underneanth it blowing upward. By leaving it in the original upright position you get quite a bit of air velocity in the small space between the booster and the mach
Electronics Forum | Thu Oct 15 10:21:30 EDT 2015 | azdback
troubleshooting a table lift error on MY12. Error code: F-MOT_Releaseboard conveyor lift/1304. Basically, the table got stuck on the up position. Also bench tested both lift motors and they are ok.Rotated the lift motors manually to test the encoder
Electronics Forum | Fri Nov 02 22:30:04 EDT 2018 | ecdave
Hello. Hoping to find help troubleshooting z axis issue. Initializes OK, and runs a bit sometimes not going all the way down to reach feeder, misses part and tries again, usually successfully, before ultimately stopping for "F-MOT-MOVE INDVACWAIT Z/2
Electronics Forum | Wed Jul 17 17:56:38 EDT 2019 | rgduval
Check the MOT board. You can usually swap out the individual MOT boards, and see if the problem moves. If it does, you can isolate which board has gone bad. You can also check the encoder on the conveyor, to make sure that is still working correct
Electronics Forum | Mon Nov 25 10:57:31 EST 2019 | rgduval
You should be able to see the counts in the service screen for the motors while testing them...that's usually the easiest way to see if they're functioning...at least the encoders. In some of the older systems, the drive motors were all the same, an
