Electronics Forum | Fri Feb 21 10:50:00 EST 2020 | tomdegas
I am getting the following error on our MY9 during hardware initialization: F-MOT-MSEDYN HYDRA Z/156 Motor Timeout After the Theta test, The HYDRA head moves slowly all the way to the bottom and then moves slowly back up and the system fails initia
Electronics Forum | Thu Mar 28 17:00:32 EDT 2024 | kingkelvin
For the hydra camera z-level - there is short section in manual - mentions using metal ruler to cover the camera - but for the other cal steps - I see nothing in the manuals for instructions - so I don't know if any special jigs are needed? I don't h
Electronics Forum | Mon Apr 08 14:07:25 EDT 2024 | kingkelvin
Hello all - so I got in the calibrate plate for hydra tool offsets - it completed the calibration - I then installed the first row of white tips with the menu - and the machine still does same thing it puts the tips away but makes a hitting type nois
Electronics Forum | Mon Apr 08 15:07:56 EDT 2024 | tey422
To me, it seems like there are slightly XY offset. Hydra might be able to pick up the tips, but not all the way securely attached to the hydra tubes. So, when the tips put back are not fully seated, which causing the tool stick inside the bank. You
Electronics Forum | Mon Apr 08 15:47:07 EDT 2024 | kingkelvin
Hi all - all good info thanks, so my indicator levels are a bit off which I knew - but I didn't realize that might be the source of this problem - after speaking with PFI and realizing the next step is to get the indicator levels to the 190 range (ma
Electronics Forum | Mon Apr 08 17:27:36 EDT 2024 | kingkelvin
I found a 0.9mm hex tool - but if I adjust the indicators "all the way up" on the shaft I get all current ranges at 255 (so obviously too high on the shaft) but if I place it anywhere else on the shaft (slightly down from top, or all the way down as
Electronics Forum | Fri Jul 19 10:19:01 EDT 2013 | rway
We have inline reworkers, so this time has been factored in. We currently use Siemens S25/20 machines with M1 systems. The placement machines run a little slower than the AOI at times so there is time to perform review, most of the time. It's not
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Wed Sep 17 11:13:06 EDT 2008 | daxman
You had mentioned that your volumes will be low? How about the mix? will you be changing over to different products a lot? How many different products will you be running? Will feeder setups be done by the operators or will you have a another departm
Electronics Forum | Thu Sep 18 17:52:49 EDT 2008 | mi
Mydata has Utility menu to "export" panel, layout, into a file, etc. And we have an Excel macro that converts all the data in this file into rows of records for each components; and save this to MSDOS csv file format giving: X,Y,Z,P/N, reference de