Electronics Forum | Fri Apr 14 09:04:15 EDT 2023 | smtusa
Has anyone run 0201 parts on mydata my9e/12e/etc series with hydra extended range head? Is it as reliable/quick as 0402? As our boards are shrinking would love to run 0201 on everything if not a headache; scared of putting myself into danger zone.
Electronics Forum | Tue May 02 15:33:23 EDT 2006 | mdm4ua
I have five Mydata machines. The 21000 number is pie in the sky. Our new My12E (2 months old) won't get close to that. Having said that, I am very happy with 0201 production with the Hydra/line scan/Linear Agilis combination. Mike
Electronics Forum | Fri Oct 07 16:29:52 EDT 2005 | bk
In 5+ years that I have been dealing with Mydata tech support, I never had any bad experiences. Their techs are very knowledgable of the machines. They are always courteous and patient,and if the problem cannot be fixed over the phone they always get
Electronics Forum | Thu Mar 22 09:49:16 EDT 2007 | Manyhatz
You shouldn't have any problem with the SM320 doing what you're asking above. In fact I think it will do it quite better. We have a two machine TP-11 Hydra line and a two machine SM320 line and I can tell you one SM320 can get the job done better.
Electronics Forum | Mon Aug 16 18:39:21 EDT 2021 | SMTA-64387687
Utility-Installation-Hydra Tool Utility "Enable Hydra Tools"
Electronics Forum | Mon Mar 26 13:51:35 EDT 2007 | grantp
Hi, Yeah, this is why we moved from MYDATA, as we could not get accurate 0402, as it seemed the vision system was not good enough. They might have upgraded this since then, but I would not recommend MYDATA for 0402 or below. Grant
Electronics Forum | Tue Dec 06 15:57:07 EST 2022 | robertobsuinc
I'm using 15E with tpsys software 3.1.2 and the machine is not using the hydra tools, hydra bank and tools are installed, package and components has the hydra tools, but is only using single mount.
Electronics Forum | Thu Mar 28 16:11:12 EDT 2024 | kingkelvin
In calibration menu - I see coarse measurement of z unit offset, z-unit offset, measure hydra camera z level, coarse adjust hydra tool offsets, and measure hydra tool lengths 1 - 8 - would it be any of these that I should run?
Electronics Forum | Mon Jan 02 09:39:34 EST 2017 | dyoungquist
I do not know the limit for component height on Hydra.