Electronics Forum | Thu Mar 28 17:13:11 EDT 2024 | tey422
It's been long time, me memories are fading away. If I remember correctly, you would need small flat surface plate or something to cover up the "linescan" hydra camera, so from the reflections value then it can calculates the actual height "lowest"
Electronics Forum | Thu Mar 28 18:00:31 EDT 2024 | alexv
The tapping noise is what you hear when Hydra taps each tool on the tool bank to make sure the tips are seated well. The error is a Z-motor problem. The gear is at the top of the Hydra and needs grease. Have you cleaned the old grease and applied new
Electronics Forum | Tue Aug 09 13:49:37 EDT 2005 | cyber_wolf
Believe it Bob. The shaft is not an off the shelf standard part. It is custom. My next step is build my own shaft from scratch. If I figure it out I will sell Hydra repair kits for 9000.00 ea. = /
Electronics Forum | Thu Sep 01 17:20:06 EDT 2005 | Mike
Is anyone currently mounting 0201's with the Hydra/Linescan combination with good results? We have a My series machine and are currently mounting the 0201's with high res camera. The results are good but it is painfully slow. Thanks in advance for
Electronics Forum | Sat Sep 26 21:45:37 EDT 2009 | casmt
It didn't see the ref points on the bottom of the hydra head. start by checking the camera for dirt or dropped parts. Is it a hydra camera or Linescan?
Electronics Forum | Sat Oct 03 07:26:01 EDT 2009 | cflames17
Check the reference plate on the hydra to make sure it is not cracked or delaminated. I have had problems with the glue coming loose and the plate flapping causing this same problem. check hydra camera calibrations, this to may help.
Electronics Forum | Thu Nov 24 16:53:03 EST 2011 | dontfeedphils
Oh wow, I suppose that would fix it huh? That's too bad that the whole unit had to be replaced, but look on the bright side, you should have a decent amount of spare hydra parts now right? haha
Electronics Forum | Fri Dec 30 09:37:53 EST 2016 | dyoungquist
Package screen and select the package you have programmed for the capacitor. Next press F3 to edit accelerations. In the popup screen set the X and both Hydras to low or lowest. That should accomplish the slow motion you are after.
Electronics Forum | Fri Dec 30 09:52:24 EST 2016 | emeto
Thanks, I will try that and we will see how it goes. Do you know what is the limit for component Height for Hydra heads?
Electronics Forum | Fri Jan 19 05:46:59 EST 2018 | ivammendes
MYDATA MY9E: Hydra's pipe can't stop the vacuum during assembly. The problem ocurre just in only one pipe, the number 5. The tool picks components but doesn't drop it. Can the problem be in the unit vacuum?
