Electronics Forum | Thu Jun 03 13:11:02 EDT 2004 | Scott B
We had an existing Mydata MY15 line and inherited 2 Quad lines (QSP2 and QSX1). We eventually had to get rid of the 2 Quads (major software and hardware issues) and have replaced these two machines with an addition single Mydata MY15 and are getting
Electronics Forum | Mon Jun 11 15:43:38 EDT 2012 | williamaxler
We are going to be moving some equipment around and our MY15 and TP11 will not fit through the door unless we take of the Y wagon. Does anyone know how to do this? If so could you please share with me.
Electronics Forum | Tue Jun 12 14:28:17 EDT 2012 | dontfeedphils
It should be pretty straight forward while taking it apart, just make sure you label things, and be ready to run through every one of the calibrations after it's put back together. Oh, and have fun Bill!
Electronics Forum | Fri Oct 12 11:16:46 EDT 2018 | tech1
Sounds like one of the Z stops is not functioning or needs to be adjusted.
Electronics Forum | Mon Nov 25 02:15:07 EST 2019 | mk15
it is possible to test x belt motor and x wagon motor.
Electronics Forum | Thu Oct 11 00:11:49 EDT 2018 | mk15
I am looking for some help for where to look to fix this MY15E problem. We started the machine after the weekend and this error code comes. F-MOT-MSETDYN z/3: Upper end point outside limit. Any suggestions? Thanks
Electronics Forum | Wed Jul 17 02:31:30 EDT 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem.After hardware initiation appear F-MOT-MSETDYN conveyor transport/1250: amplifier DC-link too high.Any suggestions? Thanks
Electronics Forum | Fri Jun 04 10:18:38 EDT 2004 | drlou
OK, I have some names to go by. I appreciate the info, especially the Quad related stuff, because my company was leaning toward the Quad, and I was concerned about its age and technology. I am going to look into the Fuji XP142E, the Samsung CP40/45,
Electronics Forum | Tue Oct 30 12:47:17 EDT 2018 | padawanlinuxero
hello try to calibrate the Z axis, check the cable must be damage, check if the transducer is loose, just some options from the top of my head, have you try getting into service and make it work there? if not try that too.
Electronics Forum | Thu Jul 18 00:08:31 EDT 2019 | mk15
hank you for the tips. MOT boards have already changed. The sensor on the conveyor responds. In service mode, the WIDTH MOTOR - OK, HOLD MOTOR - OK, SET CONVEYOR - OK, only error TRANSPORT - F-MOT-MSETDYN conveyor transport / 1250: amplifier DC-link
