Electronics Forum | Sat Apr 02 16:07:39 EST 2005 | jsk
two bent pins on the connector...replaced..works like a champ Thanks all for the help
Electronics Forum | Mon Mar 07 11:19:13 EST 2005 | cyber_wolf
Another thing : Make sure that there are no other mags plugged into the machine while you are trying to trouble shoot slot 3. I have seen shorted vibratory ID chips mess up other magazines up in different slots. For instance : a shorted vibe in slo
Electronics Forum | Sun Mar 06 11:04:19 EST 2005 | jsk
Slot three will not recognize magazine. LED's are lit (green)when inserted into slot three. Magazine works in all other slots. Tried multiple magazines. All gave the same error. Error code = E-MIPR-1 unknown magazine type slot 3 No visible damage t
Electronics Forum | Thu Mar 10 15:13:31 EST 2005 | pmd
I agree with SirTec. Conflicts with other magazines slotted into machine often cause un reckognized magazine errors elseware. You can also try to re seat the first pair of MOT driver cards in computer this is whare mag data is stored. Also a loose ca
Electronics Forum | Mon Mar 07 09:44:49 EST 2005 | anonomous
The machine sees a magazine, but with wrong number. somehow one (maybe more) wire from the magazine bus does not reach slot 3, as the other slots work, there is probably not a short, as the magazine bus work for other slots, the problem is probably i
Electronics Forum | Fri Apr 01 01:26:17 EST 2005 | Marv
A couple of things.. 1) The problem is more than likely on the magazine board itself (TC2), most likely the pal chip that stores the serial number and feeder information (you could swap this with a working magazine to verify) 2) The magazine connecto
Electronics Forum | Fri May 13 21:47:17 EDT 2022 | mikevb
I just received replacement XWB3 and 3PT1 boards. I swapped them out and it seems to have fixed that issue. Thank you all for the help!
Electronics Forum | Mon May 09 19:24:53 EDT 2022 | rgduval
It's been a minute...but, does the My9 still have MOT boards in the computer cage? If so, swap the MOTz with the MOTx or MOTy, and see if the problem moves. If so, replace the motor controller board. If not, +1 on the encoder or Z-motor. Check fo
Electronics Forum | Mon May 09 19:28:24 EDT 2022 | mikevb
Thanks for the response Rob. I will try swapping the MOT cards and see if that changes anything.
Electronics Forum | Wed May 11 20:36:32 EDT 2022 | stephendo
When was the last time you changed the flat ribbon cable on the top? Anytime I had trouble with a mydata that was the first thing they asked.
.gif)
winsouce.jpg)