Electronics Forum | Mon Nov 12 10:47:53 EST 2007 | dyoungquist
I have never used a topaz but we are currently running a TP9. I can give you some feedback on a TP9 machine. Answer a few questions first and then I can tell you if I think the TP9 is a good fit for you. What size components are you loading? Low o
Electronics Forum | Thu Nov 15 10:13:26 EST 2007 | slthomas
Not much, actually, but that was by choice. We use the Quads for short runs and when we want to get set up and torn down quickly. The Topaz was purchased specifically to give us the ability to get through our larger, regular jobs faster than we can
Electronics Forum | Fri Sep 01 16:44:41 EDT 2017 | dgaddisatprimepower
I've been struggling trying to get our TP9 machine to place 8-dfn package parts. One of our primary assembly contracts uses a SOIC8 but the pad design accommodates an alternate 8-DFN part and sometimes we have to go to our alternate part due to lead
Electronics Forum | Sat May 29 14:03:18 EDT 2010 | padawanlinuxero
Hello guys! I have a problem I had to change the MI Board on a MYDATA TP9-4 machine because it was firing 3 or more feeders at the same time, after the change it run great but then for some reason after a while it start to show an error message that
Electronics Forum | Tue Jun 01 08:42:08 EDT 2010 | rgduval
I'm randomly having some motor move errors, as well. If you swap your MOT board, and the problem continues, you're down to a couple of problems. Could be that the motor is getting ready to die on you. Could be an encoder problem. Or, could be som
Electronics Forum | Mon Nov 14 12:17:17 EST 2005 | avalancher
You should contact MYDATA service department and see what advise their phone support people can offer. You may not be doing the process correctly (wrong calibration boards, etc...)
Electronics Forum | Thu Oct 16 12:35:03 EDT 2014 | upguy
We have tpsys 1.5.18 on our TP9-UFP. We are attempting to run "Optical Centering Calibration". Following the instructions in the manual, we have centered the cross hairs on the camera frame, loaded a "base" board then the L-19-447 calibration boar
Electronics Forum | Tue May 28 05:41:48 EDT 2013 | Adrian
HI Sr Tech, I have a mydata TP9 for sale as spare parts machine. I think one of the board is defective. No feeders. Location: Malaysia. If interested , please send me a email: adrianchongyk@yahoo.com thanks Adrian
Electronics Forum | Tue Nov 15 08:17:05 EST 2005 | cyber_wolf
What are you trying to calibrate? I think you mis-typed...there is no W-wagon. I think you meant X-wagon camera. I have never seen one of these go out of cal. Why do you think it needs calibrated ?
Electronics Forum | Fri Oct 17 12:48:59 EDT 2014 | cyber_wolf
The only reason you would need to run this calibration is if the camera was replaced or the centering camera got whacked which is highly unlikely. If your placements are off, put an offset in the parameter file.
