Electronics Forum | Mon Feb 17 18:53:34 EST 2020 | richgreen01
Hi all I am experiencing z force sensor errors on a couple of different nozzles ( not hydra ) any help appreciated.
Electronics Forum | Tue Feb 18 14:37:41 EST 2020 | bk
What type of head do you have on your machine a midas head or a zi-fi head? Regardless of which you do have I would make sure that the head is clean where to tools go into the head. Use a soft swab or something similar so you do not damage the z forc
Electronics Forum | Mon Jan 28 13:40:53 EST 2019 | liquidspacie
Hello, I'm trying to fix this error and what I've done so far I cleaned (no scratches) measuring scale and swapped cards (gantry 1 & 2) and cleaned scale reader sensor. There are no spare parts, I'm just trding to narrow down the cause. Any suggestio
Electronics Forum | Thu Dec 21 17:04:28 EST 2023 | cyber_wolf
Disable the hydra head.
Electronics Forum | Sun Dec 17 13:52:59 EST 2023 | tomdegas
How can I bypass the " Hydra force sensor can't calibrate" during the "Hardware Initialization" test. This is stopping me from starting the machine.
Electronics Forum | Thu Dec 28 20:46:49 EST 2023 | padawanlinuxero
I was use to work with the machine but it has being several years since I had one in my hands, but i got the same error message, I kinda remember there are some sensors in the top part of the hydra try to see if theres dirt or something not letting t
Electronics Forum | Thu Jun 20 17:40:03 EDT 2002 | pjc
Depends on which Assembleon machine, aye? The "GEM" line, Topaz & Emerald, stuff is Yamaha- Japan, which I consider more along the lines of Juki and i-Pulse (Tenyru/Yamaha), and maybe Samsung. The "Power" line, ACM & FCM, on the other hand is pure Du
Electronics Forum | Mon Apr 20 08:32:28 EDT 2009 | cyber_wolf
I actually did replace the cable from the comp box to the X-boards. The original small x-motor was indeed bad. I verified this by taking it to my working machine and trying to pulse it when it was in my hand. (the mot boards were loaded). Then I to
Electronics Forum | Tue Oct 25 22:50:16 EDT 2005 | KEN
What is the (initial position) ratio of pulse counts to home encoder pulse (relative to the home sensor). It should be 50% +/- 15% Run this test several times in between a warm up. I bet your numbers are all over the place. I bet you have a loos
Electronics Forum | Mon Jun 12 21:16:41 EDT 2017 | kahrpr
you can not just take the motor off and change it. the motors have a home pulse singnial. the motor has to be in a certian position the home pulse position when the flag hits the sensor. When you remove the motor you have to mark the motor gear when
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
