Electronics Forum | Wed Mar 25 18:34:34 EDT 2020 | spoiltforchoice
> What about designators? Using gerbers to program > a pnp machine was always a last resort to be done > only after much complaining and begging for > proper CAD data. Back in the day I used UniCAM to > program a mydata. After gett
Electronics Forum | Fri Jul 19 13:05:56 EDT 2002 | pjc
It has been release by Mydata. I haven't used it yet.
Electronics Forum | Mon Oct 12 03:12:42 EDT 2020 | erici
TP11 is always showing the error that E-stop is not released. This happens when we start up the machine. It is basically hit and miss, sometimes will work but most of the time this error will pop up. Any suggestions on how to correct this. Is ther
Electronics Forum | Mon Oct 12 17:25:09 EDT 2020 | rgduval
Release the e-stops :) Chances are pretty good that one or more of the e-stop switches is going bad. Pop them off, and measure with an ohm-meter to figure out which one it is, and replace. I don't recall anything in the software that identified wh
Electronics Forum | Mon Aug 01 13:30:05 EDT 2022 | unisoft
>> ProntoPLACE creates programs from CAD or Gerber or XY rotation and BOM files for setup of SMT Pick & Place, thru-hole, manusert & dispensing machines, and includes the basic features of ProntoVIEW-MARKUP. Most machines are supported such as Assem
Electronics Forum | Thu Aug 04 16:08:11 EDT 2022 | unisoft
>>>> The Unisoft ProntoPLACE software ( https://www.unisoft-cim.com/pcbplace.php ) creates programs from CAD or Gerber or XY rotation and BOM files for setup of SMT Pick & Place, thru-hole, manusert & dispensing machines, and includes the basic feat
Electronics Forum | Thu Aug 04 18:17:21 EDT 2022 | unisoft
>>>> The Unisoft ProntoPLACE software ( https://www.unisoft-cim.com/pcbplace.php ) creates programs from CAD or Gerber or XY rotation and BOM files for setup of SMT Pick & Place, thru-hole, manusert & dispensing machines, and includes the basic feat
Electronics Forum | Thu Oct 20 16:11:08 EDT 2022 | cyber_wolf
I have no experience with the MY100. Personally, I'm not a fan of platforms where the PCB is not stationary. Mechanical feeders typically require more maintenance than electronic. Yamaha is one of the few I haven't worked with. It is my understan
Electronics Forum | Tue Mar 31 11:41:50 EDT 2009 | klelectronics
I receive this message everytime I turn on my machine " Release Emergency Stop Button." I checke all every loction and stop button. Cant find out the problem. Does any one have a solution to this?
Electronics Forum | Mon Oct 21 11:05:57 EDT 2019 | tey422
With the given update you provided, that would rule out the nozzle tool issue. If the parameter looks fine, then the issue would be somewhere around the nozzle tool bank. Need to check open and close release. If the nozzle seats flush "not tilted" w