Electronics Forum | Thu Mar 10 23:23:56 EST 2005 | pmd
We have a MyData TP-9-2 with a in line Y wagon. It is a long screw and the vintage is 1994. The Y wagon vibrates at about 24 micrometers at about 25 hertz. Burnin reviels zero encoder pulse errors. Hystersis test indicates a Y axis Y wise varance of
Electronics Forum | Wed Mar 16 17:43:33 EST 2005 | pmd
We grease acording to PM schedule. The cable is very old about 5 years. We run 2 shifts. The transducer program and burnin test show the varance that we are seeing phisically so I can rule out the transducer. The motor may be the cause as it is of 19
Electronics Forum | Tue Jun 14 15:59:25 EDT 2022 | mikevb
Thanks! I just needed a response like that. I will do all that, and if it's still an issue, I'll change the x wagon encoder right? There are three encoders on the x wagon though? The white one on the x carriage, the white one on the x belt drive mo
Electronics Forum | Wed Jun 15 19:46:15 EDT 2022 | mikevb
Hey All. I figured it out. It turns out that the problem was simply a loose coupler on the x wagon motor transducer. I had only checked one screw in the past but the other screw was apparently loose as well.
Electronics Forum | Mon Oct 31 02:38:18 EDT 2011 | kenmar
Hi Phil, Thanks I will contact Mydata to see about a possible software upgrade.
Electronics Forum | Thu Oct 15 10:21:30 EDT 2015 | azdback
troubleshooting a table lift error on MY12. Error code: F-MOT_Releaseboard conveyor lift/1304. Basically, the table got stuck on the up position. Also bench tested both lift motors and they are ok.Rotated the lift motors manually to test the encoder
Electronics Forum | Fri Jan 10 11:32:52 EST 2014 | rgduval
Hi, Hans, I would have suggested swapping the MOT card out to see if that fixes the issue (or, changing the MOT card with another one to isolate the card), but, it sounds like you've already done that. I'm surprised that MyData would point you towa
Electronics Forum | Mon Nov 25 02:15:07 EST 2019 | mk15
it is possible to test x belt motor and x wagon motor.
Electronics Forum | Fri Nov 22 00:09:29 EST 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem. 1. after hardware initiation appear - F-MOT-MOVE X/250: Motor speed out of control (photo1). 2. in service mode when x motor initiate appear - F-MOT-MSETDYN X/12: No axis movemen
Electronics Forum | Fri Oct 12 11:21:43 EDT 2018 | tech1
There are 2-X motors and numerous items that could be causing this: 1 of the X motors, 1 of the X transducers, 1 of the couplings connecting the motor and transducer, X Kevlar Belt. If you know how to go into the service portion of the software you
winsouce.jpg)
