Electronics Forum | Tue Jun 14 15:02:13 EDT 2022 | glasscake
Start with fundamentals: Disconnect, clean and reconnect all inner connections, bulk heads, ext. Disconnect, reconnect all connections at the controller. Check wiring harness for conductivity. Clean everything appropriately, lube ways, balls screws
Electronics Forum | Fri Jan 10 03:33:42 EST 2014 | hans88
hello people, we have a my12 wich has a problem it gives the following error during hardware initialization: F-MOT-MSETDYN Y/1236 :Motor amplifier channel a error. after this error it says hardware initialization failed. this prevents us of using
Electronics Forum | Fri Jan 10 11:32:52 EST 2014 | rgduval
Hi, Hans, I would have suggested swapping the MOT card out to see if that fixes the issue (or, changing the MOT card with another one to isolate the card), but, it sounds like you've already done that. I'm surprised that MyData would point you towa
Electronics Forum | Tue Nov 13 11:14:15 EST 2012 | jaimebc
For the past few weeks we have experienced an intermitent midas theta error.During normal production the machine times out while just after picking up a component waiting for the theta to center it.Sometimes it fails to leave a tool. Reinitianing the
Electronics Forum | Mon Nov 25 10:57:31 EST 2019 | rgduval
You should be able to see the counts in the service screen for the motors while testing them...that's usually the easiest way to see if they're functioning...at least the encoders. In some of the older systems, the drive motors were all the same, an
Electronics Forum | Fri Nov 22 00:09:29 EST 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem. 1. after hardware initiation appear - F-MOT-MOVE X/250: Motor speed out of control (photo1). 2. in service mode when x motor initiate appear - F-MOT-MSETDYN X/12: No axis movemen
Electronics Forum | Fri Nov 22 10:24:28 EST 2019 | rgduval
When you swapped the MOT card, did the proble move to another axis? I'm guessing no, but, wanted to clarify. If the problem did not move, you either have an x-motor problem, x-motor counter problem, or x-transducer problem as noted. Or, a cable pr
Electronics Forum | Fri Jun 25 17:33:23 EDT 2021 | SMTA-64387687
Since you changed the motor and the encoder, we can rule them out. Did you check the ribbon cables for wear? Is it failing on the same 3 components? Is it failing around the same area on the board? Does it fail when you cycle a tool, multiple times?
Electronics Forum | Fri Mar 11 09:42:50 EST 2005 | cyber_wolf
If you are not getting repeatable transducer readings then some possiblities are : 1. Transducer is bad 2. Motor is bad 3. Y power booster Also, I can't remember if the Y motor has a flex coupling on it or not. If it does, check that out. Also, w
Electronics Forum | Fri Dec 28 13:11:13 EST 2001 | cyber_wolf
Chris, I have worked with all kinds of Mydata's TP9,TP11,MY series machine for years. I have ran them, programmed them,and had just about every nut, bolt,motor, and circuit board out of them at one time or another.I have also written specialized mai
.gif)
winsouce.jpg)
