Electronics Forum | Wed Jun 28 15:42:37 EDT 2006 | pms
Sr.Tech, I e-mailed you. Paul M.
Electronics Forum | Thu Feb 06 10:11:45 EST 2014 | cyber_wolf
The separation clip part number for a TM8 and a TM8C are different. The TM8FC clip is longer so it will cover the component before the one being picked.
Electronics Forum | Wed Jun 28 18:05:13 EDT 2006 | Travis Eklund
I don't know about the TM8FC magazines but the Agilis magazines allow you to slow down the tape advancement speed. If you can, slow down the tape advancement on the TM8FC.
Electronics Forum | Thu Jul 06 17:37:27 EDT 2006 | pms
Travis, Thanks, but there is no adjustments (software or hardware) for tape advancement on the TM8FC magazines. Got a hold of the feeder documents from Mydata that Sr.Tech was talking about. I'll try there suggestions. Thanks
Electronics Forum | Sat Nov 20 04:32:45 EST 2021 | smtusa
Will TM series feeders (from a TP-11) run slow on a MY series machines with HYDRA head? Are there any MY series machines with dual HYDRA heads?
Electronics Forum | Sat Nov 20 12:10:37 EST 2021 | bk
Yes, you can run tm magazines on my machines but with the hydra heads they are not quite as accurate and miss pick more parts then agilis feeders. Mycronics does sell dual head machines with 2 midas heads and 2 sets of hydras
Electronics Forum | Tue Nov 23 02:23:27 EST 2021 | SMTA-64387687
The TM magazines will work exactly the same on the newer machines, as they did on your TP-11. The MY100, MY200, and MY300 series machines are all available with 2 heads, Midas and Hydra.
Electronics Forum | Wed Feb 05 14:10:18 EST 2014 | rgduval
Sometimes, those clips are adjustable, and you can slide it up to cover the part for you. Otherwise, in the past, I've always just put in a new clip when this sort of issue cropped up. Cheers, ..rob
Electronics Forum | Thu Feb 06 16:26:12 EST 2014 | alphatronique
HI SrTech yup i knot and it the good clip on the feeder i have event swap the whole clip whit the holding bard from one of my FC to the strange one and got same result so clip was not in cause and or the adjustment of the feeder
Electronics Forum | Sat Nov 20 19:54:41 EST 2021 | smtusa
Are mispicks a little more or alot more. What year did mycronics start dual head machines?