Electronics Forum | Wed Sep 30 08:29:15 EDT 2015 | johanbergstrom
The difference between TMC Flex and TMD Flex is about the ability to feed component tape with deep pockets for larger components. The TMC have a rather low passage for embossed component tape. While TMC Flex is limited to a maximum tape depth of 7,5
Electronics Forum | Mon Feb 13 11:02:05 EST 2006 | Alan
Hi Grant, Does the Flex mag have the corect pal chip in it? Some of the early Flex mags had tm8 pal chips in them. On the machine this did not have much of an effect (it did at one time allow you to have the hydra pick from the flex because the mach
Electronics Forum | Fri Aug 12 20:09:41 EDT 2005 | dorklover664
First off I would like to say it's good to be back. I haven't been working production and I'm really glad to be back. Next... I am looking for either a used MyData flex or 12/16 magazine. Cheap is the key (new company has less then 50 employees)! We
Electronics Forum | Wed Sep 23 08:19:52 EDT 2009 | rgduval
Check to see if there's a loose cable, or something, that's randomly setting off the light curtain. We occasionally have that problem with some of our flex or 12/16 mags in our TP9, where the tape take up clip is loose (nothing in that feeder) and i
Electronics Forum | Mon Jan 10 18:11:57 EST 2005 | Grant
Hi, I think I am having a bad MYDATA day. I have tried optimizing our MYDATA for the last time with this crap Myspeed software. It does not give any kind of solution unless it's perfectly happy, and so we have to run the machine again slower than i
Electronics Forum | Sat Jan 08 00:47:12 EST 2005 | Grant
Hi, Yes, one of the problems with the MYDATA is the feeders are in groups, but at the same time, they are simple, and don't break. But the new Agillis 12 and 16 mm feeders do jam a bit. It's worse on glued cover tape, while heat bonded cover tape is
| 1 |
