Electronics Forum | Wed Dec 07 13:35:11 EST 2011 | cyber_wolf
Just curious, Why do you need to attach one machine to a PC ? Throw the data on a floppy and call it a day.
Electronics Forum | Tue May 07 14:33:57 EDT 2013 | cyber_wolf
The "lowest" acceleration is probably causing your problem. Switch it to the next fastest setting and see what happens
Electronics Forum | Thu Feb 06 14:01:55 EST 2014 | rgduval
1. Fuse 2. Power Supply 3. Power Distribution card 4. Booster Start by checking all of the fuses on the front of the power supply (accessed by removing the front cover of the machine). Then, check all of the fuses on the first card in the MOT bay.
Electronics Forum | Fri Oct 17 12:48:59 EDT 2014 | cyber_wolf
The only reason you would need to run this calibration is if the camera was replaced or the centering camera got whacked which is highly unlikely. If your placements are off, put an offset in the parameter file.
Electronics Forum | Tue Oct 23 00:52:16 EDT 2018 | filipblad
Yes, for all tools... The tool head stops just above the tool
Electronics Forum | Tue Oct 23 11:18:23 EDT 2018 | tech1
It is probably one of the Z lock solenoids not working properly. These are located along the Z axis and as part of the initiation of the machine, the Z measure the travel. Check the upper and lower Z locks
Electronics Forum | Wed Oct 24 07:33:44 EDT 2018 | tech1
when the machine initiates the last move it does is in the Z axis. If memory serves me, during the last Z move it drives down and measures the stroke, if the lower solenoid is not fully retracted the axis measures the wrong travel limits. Hopefully t
Electronics Forum | Wed Oct 24 09:25:23 EDT 2018 | filipblad
The solenoids seem to work properly and there are no problems when initiating the Z-axis
Electronics Forum | Wed Oct 24 09:26:39 EDT 2018 | tech1
Correct, if the Z comes into contact on it's downward stroke during init this can cause the problem you are seeing
Electronics Forum | Wed Oct 24 10:02:17 EDT 2018 | tech1
That error points to a hardware issue. When it fails does it ask you to insert a tool manually?