Electronics Forum | Tue Mar 17 15:15:25 EDT 2015 | spoiltforchoice
In UK/Europe AdoptSMT have a range of MyData feeder bits and a reconditioning service I d believe.
Electronics Forum | Wed Mar 18 09:52:40 EDT 2015 | rgduval
You'll want to double check the electronics in the magazines, as well as the mechanicals. Over time, the connectors can come loose, and could affect performance. I'm thinking of the "dead" feeder that you mentioned, while the rest of the feeders wo
Electronics Forum | Mon Nov 12 13:35:34 EST 2007 | dyoungquist
MyData TP9s Work well in high mix applications because change over time from 1 job to the next can be done in as little as 15 minutes if you have the right mix of magazines/feeders. Component placement rates vary depending on which component you ar
Electronics Forum | Thu Feb 10 14:56:50 EST 2005 | jimdugan
The Mydata machine is a very good high mix low volume machine. If you buy from Mydata you will be better supported, than if you buy from a broker. I would recommend you buy the newer My series machine. The TP machine was a good machine but the My ma
Electronics Forum | Thu Feb 10 14:27:07 EST 2005 | cyber_wolf
First of all, whom are you getting it from ? Mydata, or a used equipment broker. If you can tell me what machine type you are looking at, then I can tell you what to look for. (MY-series, or TP series) Most important things right off the bat: *Machi
Electronics Forum | Thu Jul 18 17:38:27 EDT 2019 | rgduval
Not swapping out feeders....swapping out magazines. It only works well if you have enough extra mags to load all the feeders on. And is a viable solution if your position limited on your machine. Before the advent of Aegis feeders for My machine
Electronics Forum | Wed Oct 26 11:02:41 EDT 2011 | dyoungquist
TP9 machines are good, but old machines. We ran a TP9 for many years. As the machine got older it required more and more maintenance and had more frequent small issues similar to what you are seeing. We only saw 1 of your 4 issues specifically whi
Electronics Forum | Wed Jul 17 18:00:37 EDT 2019 | rgduval
Generally, the machines can place the same types/sizes of components. The advantage with the 11 is that you can have more magazines loaded with more components, and build larger assemblies more efficiently. The -9, though, will get you through near
Electronics Forum | Fri Jun 05 19:20:25 EDT 1998 | Rin
| Our company is currently looking to implement a SMT production line. What I am looking for is feedback on people's experiences with various machines. | Here's what we are in the market for: | Low/Mid volume 3,000+cph machine that can handle high j
Electronics Forum | Thu Jul 18 17:06:19 EDT 2019 | spoiltforchoice
I can't imagine anything more tedious than continuously swapping feeders during a build (unless your panels are 10mins++) and the very suggestion this was a good idea when were were looking at MY's was comical to me. You should expect all TP series
