Electronics Forum | Tue May 07 16:36:04 EDT 2013 | shankar2013
Actually thinking of LX14, but for now I need to solve this problem. We have replaced centering jaws, the steel belts for regular maintenance. I don't think there is anything binding. The strangest thing is every time it shuts down it is right at the
Electronics Forum | Wed May 08 09:39:14 EDT 2013 | dyoungquist
Your centering jaws are likely okay. It's the 25V that runs the centering jaws that is having the problem. Could be the circuit that produces the 25V is having problems after warmup or maybe the motor that runs the centering jaws is going bad. Loo
Electronics Forum | Thu Oct 16 12:35:03 EDT 2014 | upguy
We have tpsys 1.5.18 on our TP9-UFP. We are attempting to run "Optical Centering Calibration". Following the instructions in the manual, we have centered the cross hairs on the camera frame, loaded a "base" board then the L-19-447 calibration boar
Electronics Forum | Tue May 07 16:19:47 EDT 2013 | dyoungquist
The "25v reads 3V" part of the error message may be your clue. Since the machine runs for a while and then shuts down, something may be failing after it warms up. "F-AXIS-182:C-AXIS NOT properly out when expected" refers to the centering jaws not o
Electronics Forum | Fri Oct 17 12:48:59 EDT 2014 | cyber_wolf
The only reason you would need to run this calibration is if the camera was replaced or the centering camera got whacked which is highly unlikely. If your placements are off, put an offset in the parameter file.
Electronics Forum | Wed Sep 23 08:19:52 EDT 2009 | rgduval
Check to see if there's a loose cable, or something, that's randomly setting off the light curtain. We occasionally have that problem with some of our flex or 12/16 mags in our TP9, where the tape take up clip is loose (nothing in that feeder) and i
Electronics Forum | Tue Jul 10 11:36:22 EDT 2007 | dyoungquist
Hi SMT Frog We are using an upgraded Mydata TP9-1 system to place 0402s. We do an electrical test plus mechanical centering and use the C14 tool. A few things we have observed/learned: 1) Is the machine not picking the part up out of the tape? Po
Electronics Forum | Wed May 26 16:57:00 EDT 2010 | rgduval
Louie, We'd be interested in your experience with the stainless centering jaws. We just ran a job with heavy 0402 placements, and had a rough time with it. After much work on the package, magazine centering, etc, I've concluded the issue is the ce
Electronics Forum | Thu Jun 28 20:11:32 EDT 2007 | rfrog
Hi folks, I've been bouncing off of MyData technical support for some time on an issue with a MyData machine. Seems that this My9 likes to skip an 0402 placement at a rate of ~ 1000/million. Profile: MyData My9 Mechanical centering Midas only
Electronics Forum | Tue Jul 10 16:13:52 EDT 2007 | bk
Hi folks, I've been bouncing off of MyData > technical support for some time on an issue with > a MyData machine. Seems that this My9 likes to > skip an 0402 placement at a rate of ~ > 1000/million. > > Profile: MyData > My9 Mechanical ce
