Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Tue Feb 11 00:21:54 EST 2014 | bren
I suddenly encountered this error F-AXIS-C/9 Error says Axis has unstable zero point. Any advise?
Electronics Forum | Thu Feb 20 13:16:15 EST 2014 | rgduval
Hi, Brendan, It sure sounds like it to me. But, with the Z axis, there could be one other thing to check. On my old TP, there were z-locks...two pistons that pointed sideways around the head travel. Initializing the z-motors did not move the z-
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Fri Sep 02 04:18:48 EDT 2016 | bukas
i have tested voltages on Processor board X12. all voltages are ok and stabil but +VPP (PT8 - TP9), it reads 0 volts
Electronics Forum | Fri May 24 13:04:10 EDT 2019 | tey422
Have you tried to test the X-axis stepping? I am suspecting might have to do with the Encoder with X-Magnetic strip.
Electronics Forum | Wed Mar 06 10:58:24 EST 2013 | orlando216
Yes I can move the x1 axis, and there is no error code.
Electronics Forum | Fri Dec 10 02:49:06 EST 2010 | bagindia
we are facing vision error problem after running the machine for half an hour.Cause is x-axis motor % is changing & also motion is little harder compared with Y-axis
