Electronics Forum | Tue Feb 28 07:31:40 EST 2012 | bk
I'm assuming it's your x wagon tranducers that are out of synch. So the first place to start is look at your couplings on both x motors and make sure one of them isn't broken or starting to break. After that i would try swapping out your x board with
Electronics Forum | Tue Feb 28 08:19:03 EST 2012 | cyber_wolf
Replace both of the big X-wagon ribbon cables to start with. You always have to rule those out before looking at anything else.
Electronics Forum | Wed Feb 12 14:14:42 EST 2020 | alvarez94
I am running a MYDATA MY19 machine.the problem is that the first 2 hours after turning on the machine it does not work throwing the following error: "transducers do not agree". After approximately 1 or 2 hours the machine starts working normally. T
Electronics Forum | Wed Feb 12 14:53:21 EST 2020 | SMTA-Alex
Looks like an X-belt problem. is it tensioned correctly, not too loose or too tight? Or the X motor is acting up.
Electronics Forum | Wed Feb 12 15:11:29 EST 2020 | alvarez94
I was consulting the manual of the machine and to measure the tension of the x belt I need a frequency counter and two prisms but I don't have these tools, is there any other way to measure the tension?
| 1 |
