Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Wed Feb 06 11:24:19 EST 2002 | mrpsilva
Thanks in advance for your help. I am looking for the following board: MYDATA � Elmo EBAF 25/400RHI � controller for X axis If you need pictures, please let me know in order to send you Thanks Marcos
Electronics Forum | Tue Jun 26 15:05:02 EDT 2012 | upguy
Thanks for responding Fred and Peter. We have had the same damage to the tip occur even though our TP9-UFP sits in an air conditioned room (74 F / 23 C). I spoke with Matt at MyData (who was very helpful). He said that the X-axis bearings, the X-a
Electronics Forum | Wed Apr 06 07:59:17 EDT 2005 | cyber_wolf
Did you check the ribbon cables on either side of the X axis for cracks ?
Electronics Forum | Sat Jun 25 01:05:13 EDT 2005 | pci
check the X axis belt , guides and Z axis motor
Electronics Forum | Mon Aug 06 18:58:12 EDT 2007 | edruppert
This message indicates that the Peak to Peak voltage for the x axis motor encoder is too low. Possible cable/encoder or MOT1 board problem. Machine will either exhibit this during intialization or while running. Diagnostics in service routine may he
Electronics Forum | Thu Jul 24 11:02:29 EDT 2008 | markhoch
Try swapping the MOT card. Just be sure not to swap with the X-Axis card.
Electronics Forum | Wed Jun 27 14:36:22 EDT 2012 | cyber_wolf
If the X axis is moving then maybe your Elmo is not adjusted correctly. There is a procedure to adjust it in the manual(assuming you have the original manual). The correct location is XGTS which is a white connector on the booster. The fans are 24V
Electronics Forum | Fri May 24 13:04:10 EDT 2019 | tey422
Have you tried to test the X-axis stepping? I am suspecting might have to do with the Encoder with X-Magnetic strip.
Electronics Forum | Sun Jun 12 01:44:59 EDT 2022 | mikevb
I forgot to mention that I've measured and adjusted the cog play on the x axis and so it is within range, if that applies.
winsouce.jpg)
