Electronics Forum | Mon Feb 17 18:53:34 EST 2020 | richgreen01
Hi all I am experiencing z force sensor errors on a couple of different nozzles ( not hydra ) any help appreciated.
Electronics Forum | Tue Feb 18 14:37:41 EST 2020 | bk
What type of head do you have on your machine a midas head or a zi-fi head? Regardless of which you do have I would make sure that the head is clean where to tools go into the head. Use a soft swab or something similar so you do not damage the z forc
Electronics Forum | Mon May 09 19:27:19 EDT 2022 | mikevb
Thanks for the response. Yes, the z motor initializes in the service program just fine. It moves and reads a position. Also in the service program, I try to test the z force sensor and it gives me the same error - no z indicator at all. All cables ar
Electronics Forum | Mon May 09 19:00:47 EDT 2022 | SMTA-64387687
Z-force sensor is a tool travel indicator. It has nothing to do with Z travel. Does the Midas head move at all, during initiation? It sounds to me like a Z motor/encoder problem. Is the Midas head ribbon cable plugged in?
Electronics Forum | Wed May 11 17:25:22 EDT 2022 | SMTA-64387687
You've replaced the sensors and cleaned any grease residue inside the Midas head, and you're still getting this error. You can check the connector on the little board, on top of the Midas, where the flex cable plugs in. I don't remember, off the t
Electronics Forum | Wed May 04 19:38:57 EDT 2022 | mikevb
I have a used MyData My9 machine that I've picked up recently and it has a problem with initializing that I can't figure out. It just gives an error stating "no z indicator value at all". I've replaced the flex board with the force sensors but that d
Electronics Forum | Wed May 11 20:25:38 EDT 2022 | mikevb
Thanks. Yes, I replaced the ffx board with a new one and made sure everything is cleaned. I did check the flex cable connect as I removed all of that to test continuity between everything. It all checked out continuity wise. I also tried to disable t
Electronics Forum | Tue Jul 05 22:10:42 EDT 2022 | nellegaard
I am currently trying to setup a used MyData My19 machine and am currently having issues installing tools getting errors such as failed to pick up tool and Z force sensor failed. I have tried to clean the tool pickup area as well as clean and lubrica
Electronics Forum | Wed Jan 05 11:26:15 EST 2005 | cyber_wolf
Then Z MOTOR > Then select>CALIBRATE FORCE SENSOR NOTE: you must have a tool in the head when you do this.(Without the tip/spring pushed in) After this calibration the force should drop to 0 when you push in on the spring loaded tip. 2.) Replace th
Electronics Forum | Wed Mar 05 10:02:47 EST 2014 | dyoungquist
Per the TPSys Version 2.4 Software Manual: Force sensor level not within limits. * Force sensor dirty (inside Z tool holder) * Bad force sensor connection Try this: Remove the tool from the Z Midas head. Take a cotton tipped applicator (Q tip) and
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
winsouce.jpg)
