Electronics Forum | Thu Feb 20 13:16:15 EST 2014 | rgduval
Hi, Brendan, It sure sounds like it to me. But, with the Z axis, there could be one other thing to check. On my old TP, there were z-locks...two pistons that pointed sideways around the head travel. Initializing the z-motors did not move the z-
Electronics Forum | Fri Nov 02 22:30:04 EDT 2018 | ecdave
Hello. Hoping to find help troubleshooting z axis issue. Initializes OK, and runs a bit sometimes not going all the way down to reach feeder, misses part and tries again, usually successfully, before ultimately stopping for "F-MOT-MOVE INDVACWAIT Z/2
Electronics Forum | Fri Nov 26 15:19:53 EST 2010 | mtech88
I Just got a Mydata M9 machine, It was working at the beginning. And now the Z-axis always come up a "out of limit" problem when machine is starting up. can any one help? or come in my factory to cal. the machine for us. We are in Los Angeles, CA.
Electronics Forum | Sat Jun 25 01:05:13 EDT 2005 | pci
check the X axis belt , guides and Z axis motor
Electronics Forum | Tue Jun 26 15:05:02 EDT 2012 | upguy
Thanks for responding Fred and Peter. We have had the same damage to the tip occur even though our TP9-UFP sits in an air conditioned room (74 F / 23 C). I spoke with Matt at MyData (who was very helpful). He said that the X-axis bearings, the X-a
Electronics Forum | Tue Apr 05 05:19:30 EDT 2005 | blueflag
Breakdown help machine will not 0 set upper end point limits on Z axis Theta / lower end point missed Thanks Colin
Electronics Forum | Tue Oct 23 11:18:23 EDT 2018 | tech1
It is probably one of the Z lock solenoids not working properly. These are located along the Z axis and as part of the initiation of the machine, the Z measure the travel. Check the upper and lower Z locks
Electronics Forum | Wed Oct 24 07:33:44 EDT 2018 | tech1
when the machine initiates the last move it does is in the Z axis. If memory serves me, during the last Z move it drives down and measures the stroke, if the lower solenoid is not fully retracted the axis measures the wrong travel limits. Hopefully t
Electronics Forum | Wed Oct 24 09:25:23 EDT 2018 | filipblad
The solenoids seem to work properly and there are no problems when initiating the Z-axis
Electronics Forum | Thu Nov 01 21:44:32 EDT 2007 | daxman
Sorry everyone...you all seem to be fond of the MyData machines. I just had to make a comment. We had a TP9 for about 2 years. It rarely got used because of the terrible programming interface..When compared to Fuji Flexa and Fuji machines, we reall
winsouce.jpg)
