Electronics Forum | Sat Sep 03 13:01:36 EDT 2011 | waveroom
I'm thinking that your soldering irons are not up to the task. take a tip temperature measurement of the iron prior to and during soldering process. With high temp solder alloys you need an iron that provides continuous temperature at the tip. Doing
Electronics Forum | Fri Feb 17 14:11:32 EST 2012 | tkotwal
I'm also looking for tips for SMT hand soldering with Sn05Pb93.5Ag1.5. Our technician is quite good with standard SMT hand soldering, but hasn't worked with HMP solder. Some specific questions: - If the iron tip is hot enough (consistently), can we
Electronics Forum | Tue Aug 23 16:05:58 EDT 2011 | blnorman
Define High melting point solder
Electronics Forum | Tue Sep 11 21:24:00 EDT 2012 | vergara1
I'm also looking for tips for SMT hand soldering > with Sn05Pb93.5Ag1.5. Our technician is quite > good with standard SMT hand soldering, but hasn't > worked with HMP solder. > > Some specific > questions: > > - If the iron tip is hot enough >
Electronics Forum | Tue Aug 23 12:13:02 EDT 2011 | richieoreilly
Hi, We are currently having issues with hand soldering High melting point solder wire. Can anyone give a few tips. We are Preheating boards to 120 deg C and using soldering irons @ 410 deg C. The quality is ok but the ts taking 20-30 seconds to c
Electronics Forum | Wed Sep 12 12:08:16 EDT 2012 | tkotwal
Thanks for the advice. We have only done one PCB with HMP solder and did not use preheating, but I've been wondering if it would have been helpful since we had some trouble getting the solder to flow. If you have any more specific advice about the te
Electronics Forum | Wed Feb 20 13:49:54 EST 2013 | tkotwal
I'm looking for a preheater for hand soldering, but haven't used one before so I could use some advice. Does anyone have any preferred styles or brands? Is there anything in particular that I should either look for or should avoid? I've seen prices r
Electronics Forum | Wed Aug 24 03:12:01 EDT 2011 | richieoreilly
Hi, The solder we use is Sn5Pb93.5Ag1.5. with a melting point of about 30 degrees.
Electronics Forum | Tue Aug 23 16:48:29 EDT 2011 | jax
assuming Sn05Pb93.5Ag1.5 Without knowing what you are trying to solder, PTH or SMT, the time might not be that far off. Does that time include stripping, cleaning, plating the leads prior to soldering onto the board?... pre-tinning the board as well
Electronics Forum | Tue Sep 18 20:01:46 EDT 2012 | vergara1
Thanks for the advice. We have only done one PCB > with HMP solder and did not use preheating, but > I've been wondering if it would have been helpful > since we had some trouble getting the solder to > flow. If you have any more specific advice
.gif)
winsouce.jpg)