Electronics Forum | Mon Jun 18 08:25:59 EDT 2001 | Carl Evans
The install of the new closed loop system is totally dependant on which m/c and levell of software you have. the maximum time it should take for a older m/c that has to have new wiring run in the m/c should take no longer than five days including tra
Electronics Forum | Thu Jun 14 11:43:52 EDT 2001 | gsmguru
Change times for the Rheo pump are probably a little slower than just swapping blades. You have to hook up the sensors & air lines,remove the bottom cover + charge the pump to get it to operating pressure before you can print. I would guess that if y
Electronics Forum | Fri Jun 15 16:18:28 EDT 2001 | Dave G
Timed an actual Change today. It took about 6 min to actually change the head and then about a 2 minutes to start printing again after installing the new stencil & loading the program for the next PCB. The whole thing including stencil swap out & pr
Electronics Forum | Sat Feb 27 16:47:35 EST 2021 | petter
Looks like it was the diode inside the encoder. Are getting a new printer instead. Did a short time fix, connected a power supply to the motor and controlled the speed that way.
Electronics Forum | Tue Oct 03 16:38:26 EDT 2006 | cuculi54986@yahoo.com
You can get prototype stencils for $140 from Stencils Unlimited. I've never used their services but I have considered it. The stencils are frameless and even come with a hand squeegee for you. http://www.stencilsunlimited.com/prototype_stencils.ph
Electronics Forum | Thu May 26 16:41:00 EDT 2011 | scottp
Here's what I do: - Test Surface Insulation Resistance (we're in the high reliability market and use a test significantly harder than IPC's). I also test SIR in combination with other assembly materials like conformal coatings and wave solder flux
Electronics Forum | Fri Aug 18 05:43:51 EDT 2000 | Richard Berry
Thanks Wolfgang / Charles Have tried method suggested by Wolfgang on one product, and seem to be a bit over (perhaps density calculation was a bit out). Also, the volume of paste deposited must be less than the voume of the apetures on the stencil b
Electronics Forum | Wed Feb 03 09:34:43 EST 2016 | oxygensmd
He everyone, We have an Ekra E5 screen printer which is really nice machine I think. Now I'm looking forward a new squeegees set. I don't know the E-series and the X-series can use both squeegees? Are the squeegee holder the same on this two machin
Electronics Forum | Mon Apr 09 13:28:06 EDT 2001 | slthomas
I've been wondering if I was the only person thinking this. There are so many print parameters that are programmable now on new machines (squeegee pressure, height, speed, snap-off settings, cleaning intervals) that the process would (in my oh-so-hu
Electronics Forum | Fri Sep 29 15:33:47 EDT 2000 | Dave F
5 Paste sticking to squeegee: Squeegee is heavily magnetized Some pastes stick more than ... Plastic squeegees stick more than metal Old metal squeegees stick more than new Paste needs to be worked Paste needs to be at room temperature Some fl
