Electronics Forum | Fri Oct 23 18:13:53 EDT 1998 | Dave f
| I am looking for detailed information on the SECS 2 protocol that is part of the SEMI General Equipment Module interface. I was not able to get detailed information from the SEMI web site and was not able to find anything on the web. | | I am look
Electronics Forum | Fri Oct 23 15:15:51 EDT 1998 | Dave f
| I am looking for detailed information on the SECS 2 protocol that is part of the SEMI General Equipment Module interface. I was not able to get detailed information from the SEMI web site and was not able to find anything on the web. | | I am look
Electronics Forum | Thu Dec 03 14:45:16 EST 2015 | ttheis
Thanks. Our older oven does have a basic PC interface but no SMEMA. Maybe I can write a short program for the oven's PC to pace the boards into the oven. I could interact with the conveyor's SMEMA interface via low-cost Arduino or something similar.
Electronics Forum | Thu Dec 03 14:40:27 EST 2015 | proceng1
When we had a line that ended at an older reflow oven without SMEMA controls, I ran a momentary switch to the two pins in the connector. I push the button and the conveyor pushed the board onto the edge-hold of the oven. As a joke I labelled it "LA
Electronics Forum | Wed Nov 29 00:43:45 EST 2006 | callckq
Dear all, Recently, we run 2 models with heat sink attachment on top of this BGA(on top of this BGA, there is flip chip attached at the center of the BGA). Hence, the center of the BGA is higher than corner/side. We used conventional way to attach
Electronics Forum | Thu Oct 04 00:10:15 EDT 2018 | gaintstar
flason smt wave soldering machine: http://www.flason-smt.com/product/SMT-stencil-printer-Dek-Y-Axis-Motor-133128.html http://www.flason-smt.com/product/SMT-stencil-printer-spare-parts-Dek-Camera-181054.html http://www.flason-smt.com/product/SMT-stenc
Electronics Forum | Thu Oct 04 00:07:29 EDT 2018 | gaintstar
flason smt SMT spare parts: http://www.flason-smt.com/product/SMT-spare-parts-Assembleon-Controller-Bvm-5322-216-04698.html http://www.flason-smt.com/product/SMT-spare-parts-Assembleon-Control-V2-1-Rev-B-8mm-4022-594-10010.html http://www.flason-smt
Electronics Forum | Tue Jan 09 14:41:55 EST 2018 | bsyeo
Hi All, Need some help on this. We have a strange problem with our Dek API. There is no camera vision but everything is able to initialize well. The vision works occassionally but most of the time it does not. We have checked the nextmove card, int
Electronics Forum | Thu Aug 22 04:08:17 EDT 2002 | Jason Baldwin
Symptom: Board Stuck on Print Conveyor error messages. Cause: Board not flagging the camera sensor. Remedy: Check the following items: � Check the camera sensor can see the board underneath. � Check the camera sensor calibration (in Tools, Camera Re
Electronics Forum | Fri Aug 28 19:54:05 EDT 2020 | emeto
From what you explain: 1. check all movements X,Y and Z are moving free while machine is off. 2. Resit all driver cards. 3. Check interface cables or boards. Not sure if Juki is using CAN or other interface standard, but random motor errors might be
