Electronics Forum: no power to board rail error (Page 1 of 1)

MPM Accuflex fails to initialize powered rail

Electronics Forum | Mon Jul 21 11:01:11 EDT 2014 | dontfeedphils

I dealt with the same issue for a month or so. We jumped through a lot of hoops, replaced both lead screws, verified the motor was good, a ton of stuff. Ended up being an intermittent wire connection between the control board and the conveyor width

Board Handling Error: Waiting for output board transfer to complete, on GSM1 4681A UIC

Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina

I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the

Board Handling Error: Waiting for output board transfer to complete, on GSM1 4681A UIC

Electronics Forum | Thu Jul 28 17:35:45 EDT 2016 | travishemen

We have similar machines and they will give errors like this if the adjustable sensor on the unload end is over the fixed or movable rail.

Question to DEK users

Electronics Forum | Fri Oct 26 11:29:41 EDT 2001 | kaopsahl

I have two DEK 288s set up in our shop, we used to use a Fuji GSP_III. I could not possibly say enough good things about the DEKs - they are incredible. The only real complaint I have with them is that if an error pops up that locks up the software -

GSM1 Axis Control Error Zeroing PWC

Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer

Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits

SRX AUTOBAUD

Electronics Forum | Wed Sep 25 09:59:44 EDT 2013 | bobpan

Hello, This is from my old documents....hope it helps. I would first try mod code 53 = 2 first.....if the machine is a 2C. The motor was known for causing this problem after getting old. These are all resolutions for motor error 4. Step Potential P

  1  

no power to board rail error searches for Companies, Equipment, Machines, Suppliers & Information

fluid dispenser

Wave Soldering 101 Training Course
Win Source Online Electronic parts

Software programs for SMT placement and AOI Inspection machines from CAD or Gerber.
SMT feeders

World's Best Reflow Oven Customizable for Unique Applications
PCB Handling Machine with CE

Smt Feeder repair service centers in Europe, North, South America