Electronics Forum | Wed Apr 30 07:03:07 EDT 2008 | gemengr
DEK_265LT had been turn off and on by itsefl couple of time yesterday,and then off for good. I check the power going in to machine to the switch,got power to it,then power out to that little green box but there wasn't any power out put from that lit
Electronics Forum | Wed Apr 30 07:45:05 EDT 2008 | gemengr
Yes, it is. there's a heat sensor under of 4 resister,look like it open now.I'm thinking to make a jumper right there to see it can power up the machine.(this's a little green box on top of the transformer)
Electronics Forum | Wed Apr 30 07:50:34 EDT 2008 | realchunks
I've done it in the past. By-pass it and you'll be back in production. Make sure your power is off.
Electronics Forum | Wed Apr 30 11:41:55 EDT 2008 | gemengr
It back running now, after shut it off over night, it power back up,look like the heat sensor under of 4 resistors is start getting bad.But i'll by pass it, if it happen again. Thank you for your in put.
Electronics Forum | Wed Apr 30 07:39:29 EDT 2008 | realchunks
Is the green box on top of the transformer? If so you can by-pass it.
Electronics Forum | Wed Apr 30 08:03:25 EDT 2008 | chineechooze
You need switch out the cognex vision card.
Electronics Forum | Thu Feb 19 12:22:52 EST 2015 | dman97
Hi there. I have an IP3 machine that refuses to power up the MFU cart on side 1. I have already replaced the I/O card but still no dice. Is there a relay or fuse that I need to check to get this to power up? The machine will not operate the camera
Electronics Forum | Tue Feb 24 15:32:10 EST 2015 | swiese242
Hi there. I have an IP3 machine that refuses to > power up the MFU cart on side 1. I have already > replaced the I/O card but still no dice. Is > there a relay or fuse that I need to check to get > this to power up? The machine will not operate
Electronics Forum | Mon Jan 31 10:09:53 EST 2005 | jimmyb
1. Is it reset-able (without power down)? 2. Is this a CP41 or CP42 (only 1 D motor)? 3. Any pattern, or just random? 4. How often, once a PCB, once a hour, etc?
.gif)
winsouce.jpg)